• Smart Media Journal
• /
• v.2 no.4
• /
• pp.51-59
• /
• 2013

With increasing transmission speed of backbone networks, it is getting to provide enough available bandwidth. However, the bandwidth is not effectively utilized in volumetric data transfer. This mainly comes from the transmission protocol, TCP, which is used for most applications. TCP is inherently difficult to adapt the available bandwidth because of it's own characteristic of transfer mechanism. UDT is a prominent application level data transfer protocol which is targeting high speed network. In this paper, we propose UDT parallel transfer technologies which is adaptive to network status and then evaluate their performance in two points of view. Firstly, we measure data transfer rate of UDT with rate congestion control methods, and compare them with basic UDT. Secondly, we apply parallel transfer technologies adapted to network status, and measure their performance. Experimental results showed that UDT rate congestion control method outperforms UDT with 106% improvement in RTT 100ms section set with jitter 30ms. In addition, performance of parallel transfer with rate congestion control method showed 107% improvement than that of parallel transfer in RTT 400ms section set with jitter 20ms.

• Proceedings of the KIEE Conference
• /
• 2005.10b
• /
• pp.560-562
• /
• 2005

The electronic transmission of VLBI data(dubbed e-VLBI) presents a special challenge to the use of high-speed global network. with long-term requirements for simultaneous or near-simultaneous Gbps data streams from antennas worldwide converging in a single processing center, e-VLBI is both a useful and highly synergetic application for global high-speed networksAs broband access to high speed research and education networks has become increasingly available to radio telescopes around the world the use of e-VLBI has also increased. High bandwidth e-VLBI experiments have been achieved across wide areas e-VLBI has also been used for the transfer of data from "production"exoeriments

• Bulletin of the Korean Space Science Society
• /
• 2008.10a
• /
• pp.37.2-37.2
• /
• 2008

Korea-Japan Joint VLBI Correlator (KJJVC), to be used for Korean VLBI Network (KVN) in Korea Astronomy & Space Science Institute (KASI), is a high-speed calculator that outputs the correlation results in the maximum speed of 1.4GB/sec.To receive and record this data keeping up with this speed and with no loss, the design of the software running on the data archive system for receving and recording the output data from the correlator is very important. But, the simple kind of programming using just single thread that receives data from network and records it by turns, can cause a bottleneck effect while processing high speed data and a probable data loss, and cannot utilize the merit of hardwares supporting multi core or hyper threading, or operating systems supporting these hardwares. In this talk we summarize the design of the data transfer software for KJJVC and high speed, large capacity data archive system using general socket programming and multi threading techniques, and the pre-BMT(Bench Marking Test) results from the tests of the storage product providers' proposals using this software.

• Proceedings of the Korean Society of Machine Tool Engineers Conference
• /
• 2000.10a
• /
• pp.285-290
• /
• 2000

Unsteady-state temperature distributions and thermal deformations in high speed spindle are studied. For the analysis, three dimensional model is built considering heat transfer characteristics such as natural and forced convection coefficients Temperature distributions and thermal deformations are analyzed by using the finite element method. Results of analysis are compared with the measured data.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2012.10a
• /
• pp.407-410
• /
• 2012

Recently, wireless network services are widely used, depending on the development of wireless network module technologies and the utilization gradually expanded, and thus is a trend that appears a lot of IT convergence industries. For this study, the OBD-II communication to Import your vehicle information, and other external devices in high-speed driving condition of the vehicle to verify the information system was developed to transfer data to an external server. From various sensors inside the vehicle using the OBD-II connector easily convert all users to read the information, then, Sent to the external server using the wireless network module, high-speed vehicle status check system was implemented. It was to test the performance of the system was developed using the actual circuit in a high-speed road racing vehicles. Transfer data generated from high-speed driving vehicles through the OBD-II scanner and check the status of a high-speed vehicle system was confirmed that this data is normally received. In the future, these new cars convergence of IT technology will grow as a new field of research.

• Korea Multimedia Society
• /
• v.1 no.1
• /
• pp.19-32
• /
• 1997

There are many kinds of predominant modes to transfer Multimedia information on internet in the world. Various methods are applied to get real time multimedia data as possible as we need. At the moment it is very difficult to use acceptable technologies for performe those methods effectively on the Networks. This paper gives the alternative directions and trends for research and development of multimedia transmission on the internet. ATM is one of the best mode to transfer mass-multimedia data at the high speed on the Broad-Band ISDN until now. And xDSL (xDigital Subscriber Line) is an excellent typical method on the PSTN (Public Switched Telephone Network) using old type telephone line. But they are not yet applied into the phase of practical use together this time. So this paper analyzes what we need and how to develop the multimedia transmission modes which we can send on the internet without a problem or any difficulty for our various multimedia information all the time under low cost and high speed.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.60 no.2
• /
• pp.455-458
• /
• 2011

4:10 deserializer is proposed to recover 1:10 serial data using 1/4-rate clock. And then, 1/4-rate CDR(Clock and Data Recovery) circuit was designed for SERDES of high-speed serial display interface. The reduction of clock frequency using 1/4-rate clocking helps relax the speed limitation when higher data transfer is demanded. This circuit is composed of 1/4-rate sampler, PEL(Phase Error Logic), Majority Voting, Digital Filter, DPC(Digital to Phase Converter) and 4:10 deserializer. The designed CDR has been designed in a standard $0.18{\mu}m$ 1P6M CMOS technology and the recovered data jitter is 14ps in simulation.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.12 no.4
• /
• pp.111-118
• /
• 2012

When broadcasters want immediately a variety of VOD files in a distributed server of them data centers and away contents provider, CPs of different platform to exchange high-quality HD, 3DTV video and other video files over the IP networks of high-performance that can be transferred quickly and must be configured quickly. This paper, by using an optional encryption method to complement a QoS and security of public network, suggests high speed and secure content transmission protocol such as VPN(Virtual Private Network) for large video files and big data. As configured high performance VPN, end to end devices use the best of available resources over public network by parallel transfer protocol and the secure content delivery network.

• Journal of Communications and Networks
• /
• v.12 no.3
• /
• pp.275-284
• /
• 2010

The current multihome-aware protocols (like stream control transmission protocol (SCTP) or parallel TCP for concurrent multipath data transfer (CMT) are not designed for high-capacity and large-latency networks; they often have performance problems transferring large data files over shared long-distance wide area networks. It has been shown that SCTP-CMT is more sensitive to receive buffer (rbuf) constraints, and this rbuf-blocking problem causes considerable throughput loss when multiple paths are used simultaneously. In this research paper, we demonstrate the weakness of SCTP-CMT rbuf constraints, and we then identify that rbuf-blocking problem in SCTP multihoming is mostly due to its loss-based nature for detecting network congestion. We present a simulation-based performance comparison of FAST TCP versus SCTP in high-speed networks for solving a number of throughput issues. This work proposes an end-to-end transport layer protocol (i.e., FAST TCP multihoming as a reliable, delaybased, multihome-aware, and selective ACK-based transport protocol), which can transfer data between a multihomed source and destination hosts through multiple paths simultaneously. Through extensive ns-2 simulations, we show that FAST TCP multihoming achieves the desired goals under a variety of network conditions. The experimental results and survey presented in this research also provide an insight on design decisions for the future high-speed multihomed transport layer protocols.

• Journal of the Korean Institute of Telematics and Electronics S
• /
• v.34S no.6
• /
• pp.67-76
• /
• 1997

In radar signal processing, an A/D converter with sufficient dynamic range and high sampling speed is required to detect the weakest target signals in heavy clutter and ECM environments. As the sampling frequency increases, the amount of digital data transfered to the signal processing module is also increased. To overcome these massive data transfer burden, we need an A/D conversion module with an enough data transfer rate. In this paper, we proposed an implementation scheme of a new A/D conversio module that can be used in multi-mode 3-D phased array radar signal processing system, and evaluated the performance. The proposed A/D conversion module is implemented with a standard A/D converter and a 6U-standard VME bus.