• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.21 no.9
• /
• pp.2494-2504
• /
• 1996

This paper describes about the spread specturm radio wave propagation characteristics in urban microcells. The experiments are carried out with respect to the mean excess delay, the RMS delay spread, and the received maximum peak power in the two kinds of geogrphical areas, LOS area and N-LOS area, especially whose variations are observed while varying the transmission distance and tilting the transmitting antenna. The typical results obtained in pariticular urban sites in Seoul are 300-600 nsec of mean excess delay and about 75 nsec of averaged RMS delay spread for LOS area, and 270-280 nsec of mean excess delay and about 100 nsec for N-LOS area. With the transmitting antenna gilted, obsered in the experiments are increase in RMS delay spread as expected, but increase of the received power at N-LOS areas in particular.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.42 no.9 s.339
• /
• pp.19-28
• /
• 2005

We establish a statistical model for the ultra-wide bandwidth (UMB) indoor channel based on over 2000 frequency response measurements campaign in a Practical apartment. The approach is based on the investigation of the statistical properties of the multipath profiles measured in different place with different rooms. Based on the experimental results, a characterization of the propagation channel from theoretic view point is described. Also we describe a method for measurement of the channel impulse response and channel transfer function. Using the measured data, the authors compares channel impulse responses obtained from time-domain and channel transfer functions obtained from frequency-domain with statistical path loss model. The bandwidth of the signal used in this experiment is from 10MHz to 8.01 GHz. The time-domain results such as maximum excess delay, men excess delay and ms delay spread are presented. As well as, omni-directional biconical antenna were used for transmitter and receiver In addition, measurements presented here support m channel model including the antenna characteristics.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.8A
• /
• pp.950-961
• /
• 2004

In this paper, we measured and analyzed propagation characteristics in a subway tunnel that is recently increasingly becoming one of the radio communication environments. The measurements are carried out in a subway tunnel with frequency bands of 2.45㎓ and 5.8㎓. The length of tunnel we used for this study is 175m of LOS (Line-of-sight) and 270m of NLOS (Non Line-of-Sight). The subway tunnel is curved and its cross section is horseshoe type. The measurement systems we employ in this study are a narrow-band system and a wide-band system. The narrow-band system is used to get path loss measurement and the wide-band system is used to figure out delay profile measurement. In particular, the wide-band system consists of 1023 length PN sequence generator using a chip rate of 80MHz based on a sliding correlation technique. The omni-directional antennas and directional antennas are used to analyze propagation characteristics for beam type of antenna. The path loss displays only pure path loss of a tunnel environment. The delay profile indicates the mean excess delay and RMS (root mean square) delay spread.

• The Journal of the Acoustical Society of Korea
• /
• v.41 no.2
• /
• pp.184-191
• /
• 2022

Underwater acoustic wave in shallow water is propagated through multipath that has a large delay spread causing Inter-Symbol Interference (ISI) and these characteristics deteriorate the performance in the communication system. In order to analyze the communication performance and investigate the correlation with multipath delay spread in a reverberant environment, an underwater acoustic communication experiment using Binary Phase-Shift Keying (BPSK) signals with symbol rates from 100 sym/s to 8000 sym/s was conducted in a 5 × 5 × 5 m³ water tank. The acoustic channels in a well-controlled tank environment had the characteristics of dense multipath delay spread due to multiple reflections from the interfaces and walls within the tank and showed the maximum excess delay of 40 ms or less, and the Root Mean Squared (RMS) delay spread of 8 ms or less. In this paper, the performances of Bit Error Rate (BER) and output Signal-to-Noise Ratio (SNR) were analyzed using four types of communication demodulation techniques. And the parameter, Symbol interval to Delay spread Ratio in reverberant environment (SDR_rev), which is the ratio of symbol interval to RMS delay spread in the reverberant environment is defined. Finally, the SDR_rev was compared to the BER and the output SNR. The results present the reference symbol rate in which high communication performance can be guaranteed.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.10 no.2
• /
• pp.380-385
• /
• 2006

In this paper, a program that can be utilized to measure and analyze radio propagation characteristics is developed. This program is able to control the measurement instruments including spectrum analyzer through GPIB interface and analyze the measured data to yield mean excess delay and RMS delay spread. The measured path loss can be compared with theoretical value in free space or inside a tunnel. The measured and analyzed results can also be presented in the forms of graphs. As these tasks can be conducted on the spot of the measurements, this program is very helpful in performing and verifying the measurements immediately. In this thesis radio propagation characteristics with frequency bands of 2.45 and 5.8GHz in subway tunnels are measured by using the program. Path loss and delay spread in subway tunnel is measured and compared according to the form of antenna beam and LOS(Line of Sight) and N-LOS(Non-Line of Sight).

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.15 no.9
• /
• pp.1847-1853
• /
• 2011

Analysis of an indoor propagation channel has conventionally used the ray-tracing method. But, in this paper, we had modelling the channel for three dimensional indoor structure by the finite difference time domain method for three dimensional full wave analysis. An excitation signal of the FDTD method used plane wave. The plane wave was excited using the total field/scattered field method. And absorbing boundary condition used the perfectly matched layer method with 7 layers. An living room for the simulation of indoor channel modeling is surrounded the wall that be composed of the wood, the conductor, the glass and concrete. When there are furniture in the living room or not, it were simulated, respectively. As simulation results, we could identify the fading effect of multipath at indoor propagation environment, calculated mean excess delay and rms delay spread for the receiver design.

• Journal of Broadcast Engineering
• /
• v.5 no.2
• /
• pp.273-280
• /
• 2000

Channel characteristics between the outdoor transmitter far away from the building and receivers inside the building are explored theoretically using ray tracing technique. In this paper, 29 receivers are located on the single floor of the building to observe the variation of channel properties depending on receiver location. For each receiver, amplitudes and phases of ail the possible rays form the transmitter to the receiver are traced to obtain impulse response. Statistical results for rms delay spread and power delay profiles for representative receiver location are given.

• Proceedings of the IEEK Conference
• /
• 2003.07a
• /
• pp.314-317
• /
• 2003

In this paper, a measurement and analysis program is developed, that can be utilized to measure and analyze radio propagation characteristics. This program is able to control the measurement instruments including spectrum analyzer through a GPIB interface, and analyze the measured data to yield mean excess delay and RMS delay spread. The measured path loss can be compared with theoretical path loss in free space or inside tunnels. The measured and analyzed results can also be presented in the forms of graphs. As those tasks can be conducted on the measurement spot, this program is very helpful for performing and verifying measurements.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2003.11a
• /
• pp.589-593
• /
• 2003

Narrowband and wideband characterizations of radio propagation channels in tunnel environments are investigated by using ray tracing techniques. For a rectangular straight tunnel and a rectangular curved tunnel, received power is simulated when the receiver moves away from the transmitter. The fast fading statistics of the narrowband propagation are analyzed in terms of cumulative distribution function, level crossing rate and average fade duration. The tunnel wideband radio propagation channel is characterized in terms of mean excess delay and rms delay spread.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.12
• /
• pp.105-113
• /
• 2008

In Ubiquitous Society, accurate Location Calculation of user's device is required to achieve the need of users. As the location calculation is processed by ranging between transceivers, if some obstacles exist between transceivers, NLoS(Non-line-of-Sight) components of received signal increase along with the reduction of LoS(Line-of-Sight) components. Therefore the location calculation error will increase due to the NLoS effect. The conventional location calculation algorithm has the original ranging error because there is no transformation of ranging information which degrades the ranging accuracy. The Iterative Calculation method which minimizes the location calculation error relys on accurately identifying NLoS or LoS condition of the tested channel. We employ Kurtosis, Mean Excess Delay and RMS Delay spread of the received signal to identify whether the tested channel is LoS or NLoS firstly. Thereafter, to minimize location calculation error, the proposed Iterative Calculation method iteratively select random range and finds the averaged target location which has high probability. The simulation results confirm the enhancement of the proposed method.