• Journal of Korean Society of Environmental Engineers
• /
• v.28 no.3
• /
• pp.249-256
• /
• 2006

Catalytic combustion of toluene was investigated on the Cu-Mn oxide catalysts prepared by the impregnation(Imp) and the deposition-precipitation(DP) methods. The mixing of copper and manganese has been found to enhance the activity of catalysts. It is then found that catalytic efficiency of the Cu-Mn oxide catalyst prepared by the DP method on combustion of toluene is much higher than that of the Cu-Mn oxide catalyst prepared by Imp method with the same chemical composition. The catalyst prepared by the deposition-precipitation method observed no change of toluene conversion at time on stream during 10 days and at the addition of water vapor. On the basis of catalyst characterization data, it has been suggested that the catalysts prepared by the DP method showed uniform distribution and smaller particle size on the surface of catalyst and then enhanced reduction capability of catalysts. Therefore, we think that the DP method leads on progressive capacity of catalyst and promotes stability of catalyst. It was also presumed that catalytic conversion of toluene on the Cu-Mn oxide catalyst depends on redox reaction and $Cu_{1.5}Mn_{1.5}O_4$ spinel phase acts as the major active sites of catalyst.

• Korean Journal of Food Science and Technology
• /
• v.36 no.5
• /
• pp.754-760
• /
• 2004

Physicochemical properties and suitability of domestic wheat varieties for production of sugar-snap cookie were examined. Four kinds of commercially available wheat flour and six kinds of other domestic wheat varieties were tested. Domestic wheat varieties had protein contents ranging 7.7 to 11.5%, alkaline water retention capacity (AWRC) of 54.6 to 65.2%, Pelshenke values of 17 to 31 min, and sedimentation values of 19.6 to 30.8 mL. Peak viscosity range of Korean wheat flours measured by Rapid Visco Analyser was from 134.4 to 346.3 unit. Diameter of cookies fer US soft wheat flour was 7.8 cm and domestic wheat flours ranged from 7.2 to 7.9 cm. Cookie spread factors for Alchanmil, Tapdongmil, and Woorimil flours were higher than those of other flours. Protein content had significantly high correlation coefficient of $r=0.892^{**}$ with sedimentation value, and showed negative correlation with cookie diameter, spread factor, and top grain score. AWRC values had significantly high correlation coefficient of $r=-0.736^{**}$ with cookie diameter. Spread factor of cookie showed positive correlation with top grain score.

• Journal of Korean Society for Geospatial Information Science
• /
• v.14 no.1 s.35
• /
• pp.49-55
• /
• 2006

Nowadays, flood hazard maps have been generated to minimize the damages from the flooding. To generate such flood hazard maps, LiDAR data can be used as data source with higher data accuracy. LiDAR data, however, requires relatively higher cost and longer processing time. In this background, this study proposed DEM generation using NGIS digital topographic maps. For that, breaklines were processed to count directions of water flows. In addition, the river profile data, unique data source to represent real topography of the river area, were integrated to the breaklines to generate DEM. City of Kuri in Kyunggi Province was selected for this study and 1:1,000 and 1:5,000 topographic maps were integrated to process breaklines and river profile data were also linked to generate DEM. The generated DEM showed relatively lower vertical accuracy from mixing 1:1,000 and 1:5,000 topographic maps since 1:1,000 topographic maps were not available for some portion of the area. However, the DEM generated demonstrated reasonable accuracy and resolution for flood map generation as well as higher cost saving effects. On the contrary, for more efficient utilization of NGIS topographic maps, periodic map updating needs to be made including technical consideration in building breaklines and applying interpolation methods.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.40 no.5
• /
• pp.345-353
• /
• 2003

When designing network processors or implementing network equipments such as routers are implemented, IP lookup operations cause the major impact on their performance. As the organization of the IP address becomes simpler, the speed of the IP lookup operations can go faster. However, since the efficient management of IP address is inevitable due to the increasing number of network users, the address organization should become more complex. Therefore, for both IPv4(IP version 4) and IPv6(IP version 6), it is the essential fact that IP lookup operations are difficult and tedious. Lots of researcher for improving the performance of IP lookups have been presented, but the good solution has not been came out. Software approach alleviates the memory usage, but at the same time it si slow in terms of searching speed when performing an IP lookup. Hardware approach, on the other hand, is fast, however, it has disadvantages of producing hardware overheads and high memory usage. In this paper, conventional researches on IP lookups are shown and their advantages and disadvantages are explained. In addition, by mixing two representative structures, a new hybrid parallel architecture for fast IP lookups is proposed. The performance evaluation result shows that the proposed architecture provides better performance and lesser memory usage.

• Journal of Environmental Science International
• /
• v.16 no.10
• /
• pp.1179-1187
• /
• 2007

This paper represents the statistical characteristics of sources and receptors for road traffic noise in apartment complex. Also we suggested that the site-specific characteristics of vertical and horizontal distributions in the complex apartment have been derived using a different analysis for evaluating levels of Leq1h by the apartment floor at a given distance from a road in terms of the flow rate, the mean speed of the traffic, and the percentage of the type vehicles in the day and night periods. As a result, the contribution orders of traffic quantity by the type of vehicles showed as followed: light vehicle>medium vehicle>heavy vehicle>motorcycle. Especially, the mixing ratio of entering the road on the heavy vehicle in the daytime was two times higher than that of in the night. The speed in all types of vehicle is in the range of 41 and 81 km/hr and noise level was not significantly different in day and night-time. The sources of road traffic noise had different variations and uncertainties using a random variable and probability distribution. The sound distribution to receptors by the apartment floor showed S curve between 1st floor and $15^{th}$ floor With the normality test, the normal distributions using Anderson-Darling Test followed $1^{st},\;3^{th},\;13^{th}$ and $15^{th}$, floor in the daytime and all floors except $7^{th}$ floor in the night (p>0.05). And also, the value of the pearson correlation coefficient (r) obtained in this study have significantly different at the range of floor. In conclusion, the results suggested that the distribution characteristics of levels of $Leq_{1h}$ on the sources and receptors of road traffic noise in apartment complex must be improved and developed on the guideline of regulation of road traffic noise.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.4 no.2
• /
• pp.143-148
• /
• 2016

The aim of research is inducing the optimum proportion of fly ash(FA) and blast furnace slag(BS) for ternary cement. In this research, hence, the fundamental properties of mortar mixtures were evaluated depending on various proportion of FA and BS. The results of the experiment, within the scope of the study, obtained the following conclusions. Flow of the mixtures was increased with addition of binary supplementary cementitious material(SCM), and especially, portion of FA. The air content of the mixtures was increased with addition of binary SCMs, while it was decreased with increased FA content. In the case of unit mass, increased value was obtained due to the increased air content within 25 to 45% of binary SCM content, while it was increased within 65 to 100% of binary SCM up to only 20% of FA content and decreased more than 20% of FA because of the low density of FA. The setting time of the mixtures was delayed with addition of binary SCM and FA. In the case of compressive strength, at 91-day age, the highest value was obtained with 25 and 45% of binary SCM with the proportion of FA to BS of 40 to 60. Therefore, based on the compressive strength, it is considered that the binary SCM content of 25 and 45% with the proportion of FA to BS of 2 : 3 is the most favorable conditions in this research scope.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.8 no.3
• /
• pp.356-364
• /
• 2020

An experimental study to investigate the effect of self-cleaning of mortar mixed with photocatalyst was performed out in this study. Test parameters included the photocatalyst content and surface roughness of the specimens. The experimental mortar specimens were manufactured by mixing a photocatalyst by cement weight of 2.5%, 5.0%, 7.5% and 10.0%. In addition, the surface roughness was categorized into three cases. They included flat surface condition, little surface roughness(medium roughness), and high surface roughness. After mortar specimens were cured for 28 days, they were illuminated by an ultraviolet lamp for 24 hours and immersed in a methylene blue conditioning solution for 12 hours. Thereafter, an ultraviolet(UV) lamp was illuminated on the specimens for 48 hours in an experimental chamber and then the color change of methylene blue solution was measured by using a spectrophotometer over illuminating time of UV lamp. The color change of methylene blue tended to increase as photocatalyst contents increased. Test results meant that photocatalyst was effective for self-cleaning in mortar. However, the color change of the methylene blue solution did not show a noticeable tendency at different surface roughness conditions. It might be due to the uneven photocatalyst distribution on the surface of mortar specimens.

• Resources Recycling
• /
• v.22 no.5
• /
• pp.13-19
• /
• 2013

The effect of pH on the citrate leaching behavior of heavy metal ion was investigated to develop an eco-friendly process for removing heavy metals from soil contaminated with copper, zinc, and lead. The leaching tests were performed using citrate solution with pH adjusted by mixing citric acid and sodium citrate under the following leaching conditions: particle size, under $75{\mu}m$; temperature, $50^{\circ}C$; citrate concentration, $1kmol/m^3$; pulp density, 5%; shaking speed, 100 rpm; leaching time, 1 hour. The difference of pH before and after the leaching test was not observed, and this result indicates the direct effect of hydrogen ion concentration on the leaching of metals was insignificant. The removal ratios of copper, zinc, and lead from the contaminated soil decreased with increasing pH. The thermodynamic calculation suggests that the leaching behaviors of metal ions were determined by two reactions; one is the reaction to form complex ions between heavy metal ions and citrate ion species, and the other is the reaction to form metal hydroxide between heavy metal ions and hydroxide ion.

• Journal of Haehwa Medicine
• /
• v.12 no.1
• /
• pp.79-102
• /
• 2003

It has been believed that the human body can be effected by color, sound, smell, and taste - each of them is based on the original character. Out of these elements, the color can be a mediation that absorbs energy into human body and adapts it to the creatures whose life are definitely based on the solar energy. This thesis makes a study of the possibility of applying the color to the oriental medical science by researching the color psychology and therapy which are studied in the west medical science, the recognition and application of color developed from orientalism, and the opinion of color in the oriental medical science. Color therapy is one of the psychological treatment techniques that are able to recover and maintain the health with the rays of the sun rays and the color. The light and the color have its energy that may relax, harmonize, encourage, or excite a human being. This is because the wavelength and the vibration of each color will take effects to human body. The core energy of absorbing and distributing the color vibration is made in the 7 "chakras" in the body, which are the pith and marrow of bio-energy directly connected with the center of the nervous system. There are several methods in the color therapy - the treatment of solar ray, the color-bath, the water-therapy using color energy, the inducement of the solar energy into the body, the acupuncture, the therapy of crystal and jewel, and the self-suggestion dependent upon the color. The color therapy can help us to keep our balance by changing the emotion into the positive energy that will cure the disease with color. As a result, this method not only must be useful to cure physical disease, or develop into good health but also will be used in conforming itself to the mental disease. The color therapy mainly uses the eight colors, which are made by mixing Red, Yellow and Blue basic colors in the field. They are never used in the treatment, but they will go along with complementary colors. This rule is closely connected with the theory of yin and yang which lies at the root of oriental philosophy, and with the treatment principle of oriental medical science whose field is focused on the balancing the body mentally as well as physically. In the East, it is the Obangsaek - the color of blue, red, yellow, white, and black in the theory of yin and yang and the five elements that have been used in helping people having trouble with their health for a long time. In the view of the oriental medical science, these five colors attached the theory of five-elements have been very useful to the physiology, the pathology, or the diagnosis, and been applied to the medical treatment, combining themselves with a five-taste in medicinal herbs. Since the study of color and human physiology has been made in some different interest and fields these days, it goes to prove that the different function of color we couldn't have got before becomes very useful to the medical science. The color must be worth researching the diversity for applying itself to the oriental medical science.

• Plant Journal
• /
• v.14 no.3
• /
• pp.35-41
• /
• 2018

Considering the recent government policy toward North Korea and situation of power facilities in North Korea, it will be necessary to prepare for the consumption of the anthracite coal from Korea in coal-fired power plants. In this study, the anthracite co-fired tests in 500 MW thermal power plants were conducted with varying the main operation conditions, such as anthracite injection position in the boiler, coal fineness and combustion air flow, to investigate the effects on the generation of unburned carbon. It was confirmed that the generation of unburned carbon was remarkably reduced when the anthracite coal was injected into the boiler low burner with a relatively long residence time in the main combustion region, and that the increase of the coal fineness proportional to the combustion reaction surface area also reduces the generation of unburned carbon. An increase in the combustion air flow, which increase the combustion reactivity, also contributes to the reduction of unburned carbon. It is possible to maintain the unburned carbon generation below 5 % of the ash recycling quality by controlling the above operating conditions for the given mixing rate of anthracite, and the priority of changing the operating conditions within the test range is the highest for anthracite coal injection position.