• Nuclear Engineering and Technology
• /
• 제52권11호
• /
• pp.2479-2490
• /
• 2020

We performed experiments to measure a single-phase upward flow in a 5 × 5 rod bundle with spacer grids using a particle image velocimetry, focusing on the crossflow. The Reynolds number based on the hydraulic diameter and the bulk velocity is 10,000. The ratio of pitch between rods and rod diameter is 1.4 and spacer grid is installed periodically. The turbulence in the rod bundle results from the combination of a forced mixing and natural mixing. The forced mixing by the spacer grid persists up to 10D_h from the spacer grid, while the natural mixing is attributed to the crossflow between adjacent subchannels. The combined effects contribute to a sinusoidal distribution of the time-averaged stream-wise velocity along the lateral direction, which is relatively weak right behind the spacer grid as well as in the gap. The streamwise and lateral turbulence intensities are stronger right behind the spacer grid and in the gap. Based on these findings, we newly defined a modified mixing coefficient as the ratio of the lateral turbulence intensity to the time-averaged streamwise velocity, which shows a spatial variation. Finally, we compared the developed model with the measured data, which shows a good agreement with each other.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2009년도 세계 도시지반공학 심포지엄
• /
• pp.412-419
• /
• 2009

Large quantity of extra soils discharged from excavation site in Songdo area can be treated by hardening agents and utilized in surface stabilized layer overlying thick reclaimed soft soil deposit. Though surface layer stabilization method using cement or lime for very soft soils has been studied in recent years, but studies on moderately soft clayey silt has not been tried. The purpose of this research is to investigate optimum mixing condition for stabilizing Songdo marine soil with low plasiticity. The optimum mixing conditions of hardening agents with Songdo soil such as kind of agents, mixing ratio, initial water content and curing time are investigated by uniaxial compression test and laboratory vane test. The results indicate that strength increases with high mixing ratio and long curing time, while decreases drastically under certain water content before mixing. Finally, optimum mixing condition considering economic efficiency and workability with test results was proposed.

• 유기물자원화
• /
• 제12권1호
• /
• pp.84-93
• /
• 2004

본 연구는 생물학적 처리공정의 하나인 SBR을 이용하여, 양돈폐수중의 유기물과 질소, 인의 동시 제거를 목적으로 적정의 수리학적 체류시간(HRT)과 반응기간 중 교반/폭기 시간비(M/A) 및 적정의 교반/폭기 시간비에서의 외부탄소원의 주입기간(Injection Time)에 따른 변화에 따른 실험 결과로부터 다음과 같은 결론을 얻었다. (1) $NH_4{^+}-N$의 제거효율은 M/A가 0.0/22.0일 때(Run 1) 가장 효율이 좋았으며, 외부탄 소원을 주입했을 경우 탈질균의 증식으로 인해서 질산화가 잘 이루어지지 않기 때문에 주입시간이 길어질수록 증가하였다. T-N의 제거효율은 M/A가 증가할수록, 외부탄소원 주입시간이 길어질수록 증가하였다. (2) T-P의 제거효율은 운전조건에 따라 큰 차이를 보이고 있으며, M/A가 증가할수록 제거효율은 증가하였으며, 외부탄소원의 주입기간을 두고 보았을때, 주입기간을 짧게 할 경우 탈질균의 증식으로 인해서 탈질이 더 효율적으로 이루어지기 때문에 그 제거효율은 증가하였다. (3) 총 반응시간 22시간 중 M/A 16.5/5.5, 무산소 기간의 16.5시간 중 15시간동안 외부탄소원을 주입했을 경우(Run 4-1)의 운전조건에서 유기물 및 질소 제거에 가장 효율적이었다. 각각의 효율을 살펴보면, $COD_{Cr}$, $COD_{Mn}$ 그리고 $BOD_5$인 경우, 각각 90.6%, 87.7% 그리고 96.1%이고, T-N의 경우 86.6%, T-P인 경우는 84.5%로 나타났다.

• 한국세라믹학회지
• /
• 제36권9호
• /
• pp.893-900
• /
• 1999

Silica films were prepared on Si single crystal substrates by sol-gel process using TEOS as starting materials. Films were fabricated by a spin coating technique. Sol solutions were prepared by varying the compositions of CH3OH, H2O and DMF with fixed molar ratio of TEOS=1, HCl=0.05(mol). Wetting behavior viscosity of solutions gelation time thickness of films and cracking behavior were investigated with the various solution compositions. Wetting behaviors of solutions depended on the solution compositions mixing method and mixing rate. The optimum composition of sol was TEOS : DMF ; CH3OH: H2O :HCl=1:2:4:4:0.05(mol) and the mixing rate of solution was optimized at 1 ml/min. Viscosity of solutions were controlled by choosing a reaction time(elapsed time after mixing) at a room temperature so that we could get up to 800nm thick film The surface roughness was getting poor when thickness of films was thicker than 500nm. Thickness of coated films were increased with decreasing amount of CH3OH. The best surface roughness was obtained at the content of CH3OH 4 mol. The shortest gelation time was obtained with the content of CH3OH 8 mol. Crack-free filkms were fabricated when sintered at 500$^{\circ}C$ for 1 hr with heating rate of 0.6$^{\circ}C$/min.

• 오토저널
• /
• 제12권1호
• /
• pp.33-39
• /
• 1990

This study has been conducted by experiments for distribution of concentration of helium gas, which is jetted into stationary atmosphere at the normal temperature and pressure. It is able to obtain the data for concentration of helium and air mixtures by the use of hot wire probe which has fast response. At an up stream, the concentration gradient which is attained is steep. At a down stream, the mixing time of helium and air is gradually shortened with the lapse of time in front of a jet. The arrival frequency of a jet in an unsteady area is mostly constant from 0% to 100% up to 80mm, but the time which is reaching to 100% is gradually to lengthen as a descending downstream. After starting a jet and the point of 90%, the mixing time is especially to lengthen. This reason comes from the turbulent intensity which causes for mixing of helium and air. This time difference which causes according to lengthen a jet should be considered in the design of combustion chamber.

• 환경위생공학
• /
• 제14권3호
• /
• pp.31-38
• /
• 1999

The purpose of this study were to determine the optimum mixing ratio of sewage sludge and papermill sludge as carbon source required to SRB in treating abandoned mine drainage with natural purification wetland. If mixing sewage sludge/papermill sludge 2.0 SO42- reduced 46.2%, and then 30% in mixing ratio 0.5.Because sewage sludge was faster biodegradability than papermill sludge, effluent SCOD was 40mg/L in mixing ratio 0.5, and after that was all but regular. pH and ORP were almost neutral and -160mV, but after that was all but regular and it indicated that SRB activity was suitable. Fe removal rate was 60% in mixing ratio 2.0, and 54% in mixing ratio 0.5. In point of carbon source supply, It indicated that mixing ration 0.5 was considered as the most appropriate, because degradability of swewage sludge under short time was higher than that of papermill sludge.

• 상하수도학회지
• /
• 제25권3호
• /
• pp.367-373
• /
• 2011

Mechanism of rapid mixing effect on chemical phosphorus removal is evaluated in this study. Assuming that chemical phosphorus removal is unaffected by mixing time, only rapid mixing intensity is evaluated. In order to find out the mechanism, it is hypothesized that rapid mixing affects the Al hydrolysis speciation, and that formation of more monomeric species ($Al^a$) results in better removal of phosphorus. According to a ferron assay, more $Al^a$ formed at higher mixing intensity than at lower intensity. Subsequent experiments revealed that better phosphorus removal was obtained at higher intensity than at lower intensity, in terms of the molar ratio of $Al_{added}/P_{removed}$. The proposed hypothesis was proved in this study. Chemical phosphorus removal is affected by rapid mixing intensity due to its effect on the Al hydrolysis speciation.

• 한국전산유체공학회:학술대회논문집
• /
• 한국전산유체공학회 2007년도 춘계 학술대회논문집
• /
• pp.53-57
• /
• 2007

The quality of chaotic mixing in square cavity flow was studied numerically by CFD simulation and particle tracking technique. The chaotic mixing was generated by using time-periodic electro-osmotic flow. Finite Volume Method (FVM) was employed to get the stretching and folding field in cavity domain. With adjusting the initial condition of concentration distribution, the best values of modulation period and Peclet number which gave us good mixing performance was determined precisely. From $Poicar{\acute{e}}section$and Lyapunov exponents for characteristic trajectories we find that mixing performance also depends on modulation period. The higher value of modulation period, the better mixing performance wag achieved in this case. Furthermore, the results for tracking particle trajectories were also compared between using of Bilinear Interpolation and Higher-order scheme. The values of modulation period for obtaining best mixing effect were matched between using FVM and particle tracking techniques.

• Journal of the Korean Statistical Society
• /
• 제35권1호
• /
• pp.79-90
• /
• 2006

We consider the subdiagonal bilinear model and ARMA model with subdiagonal bilinear errors. Sufficient conditions for geometric ergodicity of associated Markov chains are derived by using results on generalized random coefficient autoregressive models and then strict stationarity and ,a-mixing property with exponential decay rates for given processes are obtained.

• Asian-Australasian Journal of Animal Sciences
• /
• 제27권4호
• /
• pp.537-542
• /
• 2014

This study was carried out to optimize cholesterol removal in whole egg using crosslinked ${\beta}$-cyclodextrin (${\beta}$-CD) and to recycle the ${\beta}$-CD. Various factors for optimizing conditions were concentration of the ${\beta}$-CD, mixing temperature, mixing time, mixing speed and centrifugal speed. In the result of this study, the optimum conditions of cholesterol removal were 25% crosslinked ${\beta}$-CD, $40^{\circ}C$ mixing temperature, 30 min mixing time, 1,200 rpm mixing speed and $2,810{\times}g$ centrifugal speed. The recycling was repeated five times. The cholesterol removal was 92.76% when treated with the optimum conditions. After determining the optimum conditions, the recyclable yields of the crosslinked ${\beta}$-CD ranged from 86.66% to 87.60% in the recycling and the percentage of cholesterol removal was over 80% until third recycling. However, the cholesterol removal efficiency was decreased when the number of repeated recycling was increased. Based on the result of this study, it was concluded that the crosslinked ${\beta}$-CD was efficient for cholesterol removal in whole egg, and recycling is possible for only limited repeating times due to the interaction of the ${\beta}$-CD and egg protein.