• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.04a
• /
• pp.63-64
• /
• 2009

Optical bounce during switching in the fringe field switching (FFS) mode using a liquid crystal (LC) with positive dielectric anisotropy has been observed. According to the analysis, it occurs at two positions which are center and edge of the pixel electrode, which decreases decaying response time. The former is major and mainly associated with increase in twist angle instantaneously during switching off resulted from decrease in tilt angle near by LC molecules at center. This paper discusses the origin of such optical bounces.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.11a
• /
• pp.162-162
• /
• 2009

Optical bounce which occurs by over twist of the liquid crystal (LC) director has a problem of response time in fringe-field switching (FFS) modes. After removing the electric field, effective birefringence ($d{\Delta}n_{eff}$) at the edge of pixel electrode meets the $\lambda/2$ phase instantly, since tilt angle of LC directors at that position suddenly decreases compared to twist angle. In this paper, based on the careful analysis, origin of optical bounce has been explained.

• Journal of the Optical Society of Korea
• /
• v.16 no.2
• /
• pp.162-165
• /
• 2012

Bow-tie modes were proposed in a grooved rectangular resonator and their lasing characteristics were investigated in semiconductor microcavities. The observed spacing between two adjacent lasing peaks from the grooved cavity was reduced compared to that of 4-bounce whispering gallery modes (WGMs) from the same-sized simple rectangular cavity due to increased round-trip path length of the bow-tie modes. The lasing spectra of bow-tie modes obtained from two adjacent corners showed highly correlated patterns while those of 4-bounce WGMs did not.

• Proceedings of the Optical Society of Korea Conference
• /
• 2003.07a
• /
• pp.90-91
• /
• 2003

정사각형 (sqaure) 구조 미소공진기는 Q값이 큰 4-bounce whispering gallery mode (WGM)가 존재 할 수 있고, 외부 도파로와 표면감쇠파 결합을 통해 상호작용할 때, 결합 길이가 매우 길어질 수 있어, 광통신용 Add／Drop Filter, 광집적회로 등의 저문턱 미소공진기 레이저 등의 광소자 분야에 적용하려는 연구가 최근 진행되고 있다. 그러나 단일 경계면을 갖는 사각 공진기는 공간 모드가 매우 많은 multimode 특성을 띄기 때문에 응용에 있어 단점이 된다. (중략)

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.2A
• /
• pp.198-203
• /
• 2008

In this paper, we consider the diffuse type of indoor wireless optical communication (WOC) system. To find the channel characteristics of indoor wireless infrared communication system, we investigate the simulation process to get the impulse response of diffuse type and analyze the scenario of the indoor structure which we have built. The simulation results of the impulse response include power ratio and time delay due to bounce times. We get and discuss the receiving power distribution according to six configurations which have different transmitter and receiver positions and reflection coefficients of the indoor structure assumed. The results of this paper are useful to design the indoor wireless optical communication systems.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.15 no.8
• /
• pp.731-735
• /
• 2002

Electro-optical (EO) performances for the twisted-nematic (TN)-liquid crystal display (LCD) photoaligned with linearly polarized UV exposure on the poly［4- (fluorocinnamate) phenylmaleimide](PFCPMI) surfaces using a new photodimerization method were investigated. For a new UVLPH (UV linearly polarized during heating) photodimerization method, the photopolymer layers were exposed by linearly polarized UV dichroic polarizer without a specific UV filter during heating at $150^{\circ}C$. The Voltage-transmittance (V-T) curve without backflow bounce in the photoaligned TN-LCD with UV exposure on the PFCPMI surface for 10 min using the UVLPH photodimerization method was observed. For response time measurement, the transmittance characteristics of the photoaligned TN-LCD using the UVLPH photodimerization method on the photopolymer surface was better than that of the photoaligned TN-LCD using the UVLP photodimerization method under a room temperature.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.05a
• /
• pp.210-213
• /
• 2004

We synthesized photoalignment material of high thermal resistance with hydroxyl aromatic polyimide, and studied the liquid crystal (LC) aligning capabilities on the photopolymer layers. Also, electro-optical (EO) performances for the twisted-nematic (TN)-liquid crystal display (LCD) photoaligned with linearly polarized UV exposure were investigated. A good LC alignment with UV exposure on the photopolymer surface can be obtained. However, the low pretilt angles were obtained below $1^{\circ}$. The Voltage-transmittance (V-T) curve without backflow bounce in the photoaligned TN cell with UV exposure was observed. The response time of photoaligned TN cell was measured about 24 ms. Finally, The photoaligned TN cell has few hysteresis, and shows the residual DC voltage that is less.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.17 no.1
• /
• pp.65-69
• /
• 2004

We synthesized photoalignment material of high thermal resistance with hydroxyl aromatic polyimide, and studied the liquid crystal (LC) aligning capabilities on the photopolymer layers. Also, electro-optical (EO) performances for the twisted-nematic (TN)-liquid crystal display (LCD) photoaligned with linearly polarized UV exposure were investigated. A good LC alignment with UV exposure on the photopolymer surface can be obtained. However, the low pretilt angles were obtained below 1$^{\circ}$. The Voltage-transmittance (V-T) curve without backflow bounce in the photoaligned TN cell with UV exposure was observed. The response time of photoaligned TN cell was measured about 24 ms. Finally, The photoaligned TN cell has few hysteresis, and shows the residual DC voltage that is less.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.19 no.3
• /
• pp.260-266
• /
• 2006

In this paper, We coupled fluid balance and director balance equation from Ericksen-Leslie's continuum theory and observed the motion of Liquid Crystal molecular. We simulated flow velocity and director distribution in which flow effect is considered in switching on and switching off state. We interpreted the dynamic response characteristic caused by the flow. As the result of the simulation, We could see the flow effect. In the case of Twisted Nematic(TN) cell, this flow caused abnormal twist temporarily in switching off state. We could prove that this abnormal twist is a direct cause of optical bounce phenomenon known well until now with the result of simulation. In addition, We analyzed the mechanism of the fast response due to flow in the case of Optically Compensated Bend(OCB) cell.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.11a
• /
• pp.502-505
• /
• 2003

We synthesized high thermal photoalignment material with hydroxyl aromatic polyimide, and studied the liquid crystal (LC) aligning capabilities on the photopolymer layers. Also, electro-optical (EO) performances for the twisted-nematic (TN)-liquid crystal display (LCD) photoaligned with linearly polarized UV exposure were investigated. A good LC alignment with UV exposure on the photopolymer surface can be obtained. However, the low pretilt angles were obtained below $1^{\circ}$. The Voltage-transmittance (V-T) curve without backflow bounce in the photoaligned TN cell with UV exposure was observed. The response time of photoaligned TN cell was measured about 24 ms.