• Journal of the Korean Applied Science and Technology
• /
• v.29 no.4
• /
• pp.585-593
• /
• 2012

The EO separation and quantitative determination of polysorbate 20, polysorbate 40, polysorbate 60 and polysorbate 80 was carried out by reversed phase HPLC. The water/acetonitrile was used for the mobile phase of gradient conditions. An YMC Pack Ph ($250mm{\times}4.6mm$ i.d., $5{\mu}m$) and Phenomenex C4 ($250mm{\times}4.6mm$ i.d., $5{\mu}m$) and the selected ELSD detector was applied. The analysis results of HPLC showed good linearity with correlation coefficient of $r^2$=0.997 in the rage of $180.2{\sim}980.5{\mu}g/mL$ and detection limit.

• Journal of Pharmaceutical Investigation
• /
• v.39 no.2
• /
• pp.107-110
• /
• 2009

To investigate the interaction and skin damage of valsartan with polysorbate 80, the physical mixture of valsartan and polysorbate 80 was prepared and then its adhesion, dispersibility, DSC and skin damage in nude rats were investigated. The physical mixture of valsartan and polysorbate 80 appeared as an aggregated form and could hardly be dispersed in water. The DSC curve showed that physical mixture disappeared the intrinsic peaks of valsartan and polysorbate 80 at about $115^{\circ}C$ and $170^{\circ}C$, respectively. It appeared a new relatively broad endothermic peak at about $150^{\circ}C$, suggesting that valsartan was chemically interacted with polysorbate 80. Furthermore, it induced the severe skin irritation and damage in nude mice. Thus, polysorbate 80 must not be used in the preparation of valsartan-loaded pharmaceutical dosage forms.

• Korean Journal of Food Science and Technology
• /
• v.52 no.6
• /
• pp.670-677
• /
• 2020

To prevent contamination by Campylobacter jejuni during chicken carcass processing, the effect of emulsifiers on C. jejuni inoculated on chicken skin was investigated using confocal laser scanning microscopy. Among the 8 emulsifiers (SWA-10D, L-7D, M-7D, S-1670, L-1695, P-1670, polysorbate 20, polysorbate 80) tested for antimicrobial activity by the paper disk method, 4 emulsifiers (L-7D, L-1695, polysorbate 20, polysorbate 80) were screened further. Emulsifier L-1695 showed the largest clear zone at a concentration of 200 mg/mL. The 4 emulsifiers subjected to primary screening were screened for heat and pH stability. In the contact surface test, emulsifier L-1695 showed the lowest log CFU/㎠ value on both stainless steel and ceramic surfaces. When emulsifier L-1695 was applied via general and electrostatic spray methods, the number of C. jejuni entrapped inside chicken skin follicles was significantly reduced in both methods. In conclusion, the emulsifier L-1695 could be employed as a microbial detachment agent in the chicken carcass processing industry.

• The Korean Journal of Food & Health Convergence
• /
• v.5 no.4
• /
• pp.13-17
• /
• 2019

Amiodarone hydrochloride is an antiarrhythmic agent which has low aqueous solubility and presents bioavailability problem. These properties are a challenge for the pharmaceutical industry. Inclusion of lipophilic compound in the hydrophobic core of micelles, i.e. self-assembled structures based on surfactants in aqueous solution, is one way of increasing the solubility. Intravenous formulation of amiodarone hydrochloride with polysorbate 80 as a detergent and benzyl alcohol as a co-solvent is used in medical practice. This paper aimed to study the effect of polysorbate 80 and benzyl alcohol on the water solubility of amiodarone hydrochloride. Formation of mixed micelles consisting of nonionic surfactant polysorbate 80 and cationic amiodarone with chloride counterion was investigated by fluorescence spectroscopy. Benzyl alcohol was found to decrease the stability of the mixed micelles and lead to crystallization of amiodarone hydrochloride. The greatest amounts of crystals formed at 4℃ for 30 days in the model drug solutions with polysorbate 80 concentrations of 100.1 mg/mL and 97.9 mg/mL. A change of the polysorbate 80 concentration and avoidance the use of benzyl alcohol are recommended to improve the stability of the parenteral dosage form. These results can open new perspectives in the optimization of amiodarone intravenous formulations.

• Korean Journal of Food Science and Technology
• /
• v.31 no.4
• /
• pp.1029-1034
• /
• 1999

To enhance the cleaning and sterilization effect of cooled electrolyzed acid water on lettuce, several kinds of polysorbates were used at various concentrations in immersion washing process. In case of the treatment containing polysorbate 20, coliform count of lettuce was reduced to about 1/40 level of that in non-treated lettuce. The treatment containing polysorbate 60 did not show a significant sterilization effect. Otherwise, the total and coliform counts of lettuce during immersion in electrolyzed acid water containing 1 ppm of polysorbate 80 was reduced to about 1/300 and 1/1,700 level of those in non-treated one. And, the changes of ORP(oxidation-reduction potential), pH and color value of lettuce in electrolyzed acid water containing 1 ppm of polysorbate 80 were not quite different during 60 min. immersion, but HCIO content decreased from 10.28 ppm to 8.51 ppm after 20 min. immersion. Also, total and coliform count of lettuce immersed in electrolyzed acid water containing 1 ppm of polysorbate 80 was lower to about 1/1,800 after 20 min. and 1/5,550 after 30 min, compared with non-treated lettuce.

• YAKHAK HOEJI
• /
• v.32 no.6
• /
• pp.371-376
• /
• 1988

The effect of polysorbate 40, used as a surfactant during the process of manufacture, on the properties of cytarabine microspheres with carnaubu wax was studied. It was revealed that the mean particle size increased in proportion to the concentration of polysorbate 40, and that the dissolution rate of the cytarabine from the microspheres decreased greatly more than the cytarabine powder only, but increased in proportion to the concentration of polysorbate 40 as surfactant.

• Food Science and Preservation
• /
• v.9 no.2
• /
• pp.240-247
• /
• 2002

This study, to enhance the sterilization, browning inhibition and precooling effect of electrolyzed oxidizing water(EOW) as cleaning water on food industry, was carried out to investigate the efficacy of electrolyzed oxidizing water(EOW) with 0.85% NaCl, 0.5% ethanol, polysorbate 80 of 1 ppm, 0.5% lemon juice and 0.5% citron juice. Escherichia coli KCTC 1039 with initial count of 5.63$\times$10$\^$8/ CFU/mL were reduced to <10$^1$CFU/mL after 15∼30 sec when it was treated by electrolyzed oxidizing water added with various food additives. Bacillus cereus KCTC 1012 were reduced to <10$^1$ CFU/mL after 2 minutes treatment with electrolyzed oxidizing water containing polysorbate 80 and ethanol. Iactobacillus plantarum KCTC 3108 were reduced to <10$^1$CFU/mL after 30 sec treatment with electrolyzed oxidizing water containing polysorbate 80, citron juice and lemon juice, respectively. Erwinia carotovora subsp. carotovora KCTC 2776 were reduced to <10$^1$CFU/mL after 30 sec treatment with electrolyzed oxidizing water containing polysorbate 80 and lemon juice. Browning inhibition effect was determined by comparison of polyphenol oxidase activity. Inhibition ratio of polyphenol oxidase was approximately 62∼84% in most treatments with the exception of 57% and 25% inhibition by 0.5% ascorbic acid and polysorbate 80, respectively. Sliced potato dipped in electrolyzed oxidizing water containing NaCl and citron juice for 30 minutes showed significantly low PPO activity, 64 units in treatment with NaCl and 91 units in treatment with citron juice. At the same time, changes in color value(△E) of sliced potato was below 3 in most treatments.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.34 no.3
• /
• pp.175-181
• /
• 2008

Cellolose nanoparticles loaded with retinyl palmitate were prepared by modified spontaneous emulsification solvent diffusion method. We used polysorbate 20, polysorbate 60, and PPG-26-Buteth-26/PEG-40 Hydrogenated castor oil as dispersion medium. The optimum condition for particle size of cellulose nanoparticles was 1w/v% ethyl cellulose with, 3w/v% polysorbate 60 solution. And The optimum condition for leading amount of retinyl palmitate of cellulose nanoparticles was 2w/v% ethyl cellulose with 1w/v% polysorbate 60 solution. Also, we found that this optimum condition can be applicable to other active compounds.

• Proceedings of the SCSK Conference
• /
• 2003.09a
• /
• pp.258-267
• /
• 2003

Recently inside nano liposome particles or nano-emulsions which contain tough-melting physiology activity materials or the coefficient of low organism utilization promote the coefficient of organism utilization, so this part has been studied a lot because they can absorb selectly cosmetics, specially physiology activity materials, into the skin. Also, in particle size, cells interstitial lipid interval are 30~50nm, so nano-emulsions that the size is similar to 30~50 nm are made to study for absorbing quickly into the skin. And transparent skin which contains oils in common skin lotion dosage form has become the center of public interest. The used nano-emulsions in this study were unsaturated lecithin/co-surfactant! ethanol/ oil / water. And polysorbate 20/ polysorbate 80/ Dicetyl phosphate/hydrogenated .caster oil/ isoceteth-20/SLS were used in co-surfactant. The used oils were cyclomethicone and caprylic/capric triglyceride. The manufacturing process was that microfluidizer was fixed in 1000bar and transit times were changed from 1 to 10 times. From transparency and particle size, the transparency sequence was SLS> polysorbate 20= polysorbate 80> isoceteth-20> dicetyl phosphate >hydrogenated caster oil and the particle size was small. Specially cyclomethicone nano-emulsions, when we made unsaturated lecithin /SLS /ethanol/water/cyclomethicone, cyclomethicone 5％ was good for transparency. And 20％ of this was used for making transparent skin toner in common skin dosage form.

• Bulletin of the Korean Chemical Society
• /
• v.33 no.5
• /
• pp.1566-1570
• /
• 2012

The combined use of indium and polysorbate 20 (Tween 20) was considered as a new inhibition technique for zinc corrosion. Zn and Zn-In alloy coatings were prepared by electrodeposition and their morphology and composition were characterized by scanning electron microscopy (SEM) and inductively coupled plasma atomic emission spectrometry (ICP-AES). The corrosion inhibition effect of indium and Tween 20 on zinc was investigated by polarization curves and electrochemical impedance spectroscopy (EIS). The corrosion inhibition efficiencies obtained from Tafel and EIS analyses are well in agreement. Zinc corrosion can be inhibited to some extent by the individual use of indium and Tween 20 and higher corrosion inhibition efficiency can be obtained by the combined use of indium and Tween 20.