• Journal of environmental and Sanitary engineering
• /
• v.21 no.1 s.59
• /
• pp.12-20
• /
• 2006

This paper was conducted concerning the degree of indoor air quality in public transport vehicles such as taxicabs, buses and subway trains, as sampled through the active participation of drivers and passengers in Seoul between 13th August 2005 and 2nd November 2005. The results were summarized as follows: 1. Among the measured substances especially respirable particulate matters ($PM_{10}$), total bacteria counts (TBC) and carbon dioxide ($CO_2$) exceeded the standard level of $150{\mu}g/m^3,\;800CFU/m^3$ and 1000ppm. 2. The concentration of carbon dioxide ($CO_2$) in taxi recorded 2491ppm, which is more than the standard amount of 1000ppm. This level was comparatively higher than all other public transportation methods. Total bacteria counts (TBC) in bus and subway recorded $1082CFU/m^3\;and\;1856CFU/m^3$, respectively. 3. The drivers who regularly work long hours showed the higher concern about contamination of the air inside the public transport vehicles and they considered it to be worse than the air outside. In contrast, the general public showed less concern about the air quality inside the public transport vehicles. However, they too acknowledged that the quality of the air inside the public transport vehicles was poor. In regards to the degree of indoor air quality in the public transport vehicles, a counterplan must be implemented urgently to effectively combat the excessive levels of $PM_{10}$, microorganism and $CO_2$. We need to gather more conclusive evidence pertaining to other possible contaminants and influencing factors.

• Industrial Engineering and Management Systems
• /
• v.13 no.2
• /
• pp.172-184
• /
• 2014

Economic growth with rising household income has put more vehicles on the roads worsening traffic congestion, road accidents, and air and noise pollution. This situation is further aggravated by the potential working population who choose to drive to work instead of taking public transportation. Public bus transport (PBT) plays an important role in alleviating these problems. PBT is underutilized in Malaysia, and there is an opportunity to increase ridership without substantial investment. Therefore, this study was conducted to investigate the factors that influence the use of PBT in Malaysia. The data were collected using structured questionnaires from 400 respondents. The results of the analysis show that the twin factors consisting of perceived satisfaction of and perceived importance by users towards safety and comfort of facilities and services offered by PBT are significantly related to intention to use those services. The satisfaction of availability of season tickets, the importance of reliability of bus schedule and time table, and the importance of ticket pricing are also significant. By providing insights for both public bus operators and the government, this paper contributes to mitigate the underutilization of PBT in Malaysia and the consequences of putting more vehicles on the roads. From the theory perspective, this paper also contributes by extending the theory of reasoned-action to transportation studies.

• 한국ITS학회:학술대회논문집
• /
• 2005.11a
• /
• pp.83-88
• /
• 2005

A transportation problem in Korea is a serious issue that has to be solved urgently in the motor era of 15 million vehicles. Recently ITS has been introduced to improve efficiency of the current roads because an excessive budget and a long term construction are needed to build new roads. Therefore the government enacted the law as of ITS and the in architecture. However, these ITS information services were oriented to mainly vehicles and drivers, not public entities such as bus driver, passengers and so on. Nowadays lots of local autonomous city introduced a public transportation information system (PTIS), and providing useful information for the public. For this PTIS, important design issues are to be focused on detecting and tracking technology of moving bus, and a wireless communication link to transmit the location information. This paper presents design models using several wireless communication methods, and an implementation case using a Wireless packet Data communication Network (WDN) to transmit bus location information at Seoul, Korea.

• Particle and aerosol research
• /
• v.11 no.1
• /
• pp.1-8
• /
• 2015

In this study, indoor $PM_{10}$ concentration was measured by different type of real-time instruments in public transport vehicles. Light-scattering method is widely used in measuring the size of particulate matters and there is two types of light-scattering methods; one is the nephelometer type which measures the light-scattering degree by aerosol cloud, the other is the spectrometer type which measures light-scattering degree by individual particle. We observed the variation of $PM_{10}$ in KTX, subway and express bus carriages by 1-minute resolution and found that there is similar tendency in pattern among 4 light-scattering devices but difference in absolute concentrations. By comparing gravimetric result in a subway cabin, the spectrometer type device, C, was chosen as a reference device. The conversion factors of nephelometer device A-1, A-2, and B were 1.666, 1.463 and 2.125 respectively.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.15 no.4
• /
• pp.1216-1231
• /
• 2021

With the increase in the population of our cities and the rapid increase in the number of private cars, urban traffic has become more and more congested. At this stage, urban public transportation has become one of the main ways to improve urban traffic congestion. Aiming at the problem of how to improve the basic capacity of buses in multi-line transfer stations, this paper conducts simulation research based on anylogic software. Through micro-simulation analysis of vehicles entering, stopping, and exiting the station, combined with the delay model theory, the vehicle is given Stop organization optimization and station layout improvement methods, so that vehicles can run in the station more stably, smoothly and safely. Case analysis shows that applying this method to the roadside parking problem, the main and auxiliary bus stations have a significant improvement in operating capacity compared with the conventional tandem double bus stations, and the service level of the main and auxiliary bus stations has been significantly improved.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.19 no.5
• /
• pp.82-96
• /
• 2020

The Demand Responsive Transit (DRT) system is the flexible public transport service that determines the route and schedule of the service vehicles according to users' requests. With increasing importance of public transport systems in urban areas, the development of stable and fast routing algorithms for DRT has become the goal of many researches over the past decades. In this study, a new heuristic method is proposed to generate fast and efficient routes for multiple vehicles using demand clustering and destination demand priority searching method considering the imbalance of users' origin and destination demands. The proposed algorithm is tested in various demand distribution scenarios including random, concentration and directed cases. The result shows that the proposed method reduce the drop of service ratio due to an increase in demand density and save computation time compared to other algorithms. In addition, compared to other clustering-based algorithms, the walking cost of the passengers is significantly reduced, but the detour time and in-vehicle travel time of the passenger is increased due to the detour burden.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.26 no.1
• /
• pp.31-43
• /
• 2023

In this paper, we propose a method for generating a global path for an unmanned vehicle using public data of road section information. First, the method of analyzing road section information of the Ministry of Land, Infrastructure and Transport is presented. Second, we propose a method of preprocessing the acquired road section information and processing it into meaningful data that can be used for global routes. Third, we present a method for generating a global path using the preprocessed road section information. The proposed method has proven its effectiveness through actual autonomous driving experiments of unmanned ground vehicles.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.12 no.4
• /
• pp.33-43
• /
• 2013

Comparing to the constant-increasing number of vehicles, road facilities supply such as road construction has already reached the uppermost limit. As one of the most serious issues that the public would personally deal with every day, such is some road traffic problem to be solved instantly. Median exclusive bus lane is now being conducted as a way to enhance efficiency of the public transportation system in Transportation System Management, and with a main arterial that connects Kyeryong-ro (Wolpyeong 3~West Daejeon 4, 6.3km) and Daedeok-daero (Daedeok Bridge 4~Kyeryong 4, 2.6km) in Daejeon adopted as a research target, the study analyzed effects of the arterial by VISSIM the microsimulation. During the analysis, the study focused on figuring out effects of owner-drivers' transport mode choice to take a bus a public transit. According to the simulation results, as people take a bus at the median exclusive bus lane not crb bus lane, traffic for general vehicles has been negatively effected with less drive ways for the vehicles. However, when it comes to the bus traffic, the new transport mode choice appeared to have a quite positive influence after all. A binary logit model analysis reported that owner-drivers might take a bus more often when they earn lower incomes, when they do not travel far, when poor parking is expected and lastly, when they are familiar with using the median exclusive bus lane.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.21 no.6
• /
• pp.1-20
• /
• 2022

The basic way to charge vehicles for using road and public transport networks is the entry-exit toll system. This system works by reading Hi-Pass and public transportation cards of the vehicles using card readers. However, the problems of navigating a route in consideration of entry-exit toll systems include the non-additive costs of enumerating routes. This problem is known as an NP-complete task that enumerates all paths and derives the optimal path. So far, the solution to the entry-exit toll system charging has been proposed in the form of transforming the road network. However, unlike in the public transport network where the cards are generalized, this solution has not been found in situations where network expansion is required with a transfer, multi-modes and multiple card readers. Hence, this study introduced the Link Label for a public transportation network composed of card readers in which network expansion is bypassed in selecting the optimal path by enumerating the paths through a one-to-one k-path search. Since the method proposed in this study constructs a relatively small set of paths, finding the optimal path is not burdensome in terms of computing power. In addition, the ease of comparison of sensitivity between paths indicates the possibility of using this method as a generalized means of deriving an optimal path.

• The Korean Journal of Emergency Medical Services
• /
• v.22 no.3
• /
• pp.177-187
• /
• 2018

Purpose: The purpose of the study was to investigate the causes of non-transport in 119 ambulance services and to describe the difference in response time according to the reason for non-transport. Methods: This study analyzed 42,415 non-transport cases out of 123,158 cases using prehospital care reports in a metropolitan city. The Kruskal-Wallis test and the Wilcoxon-Mann-Whitney test were used to 6,857 cases for which time was recorded. Results: Non-transportation in 20${\bigcirc}{\bigcirc}$ comprised 33.1% of all ambulance services. The reason for non-transport were other reasons (25.5%), cancellation (23.8%), and moving to other vehicles (21.7%). There were differences in ambulance service times according to the reasons for non-transport. The activation interval was the longest (2.68 minutes) in the absence of the patient, and the response interval was the shortest (4.96 minutes) among the cancelled case. The total interval was the shortest time (21.97 minutes) in the cancellation cases and the longest time among the death cases (32.23 minutes). Conclusion: It is important to suggest the direction of development of emergency services by identifying the reasons for non-transport by ambulance services and describing the response time according to the reason for non-transport.