• Journal of the Korean GEO-environmental Society
• /
• v.10 no.1
• /
• pp.43-48
• /
• 2009

This study was performed to investigate the characteristics of nutrient removal by Sequencing Batch Reactor (SBR) system, which could achieve high removal efficiencies of nitrogen and phosphorus and make it possible convenient management and operation. In this study, dissolved oxygen (DO), chemical oxygen demand (COD), nitrogen, and phosphorus in SBR system were examined by variation of anoxic-oxic phase repetition in order to optimize an operational method. The 1~4 times of anoxic-oxic phases (Run 1~4) were repeated during 1 cycle operation period. As the repetition frequency increased, it was more difficult to maintain DO condition enough for denitrification. The SBR system showed high COD removal efficiency more than 91% regardless of operational condition. About 68% of nitrogen removal rate was obtained in conditions of 2 or 3 times repetition of anoxic phases, in which NOx-N among discharged total nitrogen account for more than 99%. Approximately 40% of phosphorus was eliminated in the conditions of 1~3 times of anoxic phase repetition.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.48 no.11
• /
• pp.730-734
• /
• 1999

In this study, it is the purpose to develope a cheap and compact repetitively pulsed $CO_2$ laser with pulse repetition rate range of 180 Hz. We used a SCR switched power supply as a high voltage pulsed supply, which is cheap and simple comparing to others. PIC one-chip microprocessor was used for precise control of a laser power supply on the control part. And the laser cavity was fabricated as an axial and water cooled type. The laser performance characteristics as various parameters, such as pulse repetition rate and gas pressure have been investigated. The experiment was done under the condition of total pressure of $CO_2, N_2$ and He from 4 Torr to 16 Torr and pulse repetition rate from 4 Hz to 180 Hz. As a result, the maximum average output was about 19.6W at the total pressure of 12 Torr and the pulse repetition rate of 180Hz.

• English Language & Literature Teaching
• /
• v.16 no.1
• /
• pp.143-170
• /
• 2009

The purpose of this experimental study is to investigate the effects of repeating vocabulary exercises on learning and retaining the meaning, the form, and the use of L2 words. To achieve this purpose, the data from the 87 participants who performed the assigned vocabulary exercises were collected immediately and two weeks later on their learning and retention of the target words. In addition, their attitudes toward the given vocabulary exercises were examined. The results show that the participants repeating exercises showed significantly better results in the immediate posttest, whereas no significant differences were found in the delayed posttest. Consequently, although the repetition effect influence positively on the learning of the target words, these effects are not maintained if they are not reinforced subsequently after the initial introduction to them. Most of the participants in this study identified the importance of repetition in learning new words and also noted that only one encounter with words was not enough for them to acquire the words fully.

• Journal of IKEEE
• /
• v.12 no.4
• /
• pp.234-238
• /
• 2008

We demonstrate a simple method to generate a stable 40 GHz pulse train at 1550 nm by spectral filtering of a 10 GHz mode.locked pulse source using a fiber Fabry-Perot interferometer (FFPI). A high finesse FFPI with a 40 GHz free spectral range blocks successfully unwanted spectral components of a 10 GHz pulse source and passes only 40 GHz spaced spectral lines ensuring pulse repetition-frequency quadruplication of the input pulses.

• Textile Coloration and Finishing
• /
• v.15 no.1
• /
• pp.1-7
• /
• 2003

To study the dyeability(ΔE value) and color depth of silk fabrics dyed with Impatiens balsamina extracts. its flower, leaf and stem was extracted by water. This paper investigated some experiments under the various dyeing conditions such as dyeing temperature, dyeing time, repetition of dyeing, dyeing pH with silk fabrics dyed with Impatiens balsamina extracts. The results obtained were as follows 1. It was found that $\lambda_{max}$ of silk fabrics dyed with Impatiens balsamina extract was 260nm and its flower, leaf , stem and different colored flower(white, pint violet) had same $\lambda_{max}$ at 260nm. 2. $\Delta{E}$ values were increased when dyeing temperature, repetition of dyeing and time was higher, value of munsell of silk fabrics dyed with Impatiens balsamina extract was Yellow-Red. But dyeing temperature, repetition of dyeing and time was higher, shifted to longer wavelenth side. 3. Silk fabric dyed with Impatiens balsamina extracts at acidic pH was colored reddish Yellow-Red, alkali bath colored yellowish Yellow-Red in silk fabrics dyed with Impatiens balsamina extract.

• Korean Journal of Optics and Photonics
• /
• v.14 no.5
• /
• pp.515-520
• /
• 2003

Characteristics of an amplifier with repetition rate of a few KHz is investigated. The continuous flash lamp pumped Nd:YAG laser head is used as an amplifier. The thermally induced birefringence of the laser medium is compensated and the depolarization is reduced to 5% in a double-pass amplifier. The amplification factor of a four pass amplifier reaches to about 3.2 at the repetition rate 5-10 KHz and the pulse width is lengthened from 40 ns to 48 ns.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2006.03a
• /
• pp.670-675
• /
• 2006

The purpose of this study is the infiltration characteristics of soil cut-slope by the repetition & concentration rainfall. The maximum rainfall concentrate from June until September which is a rainy season in our country Stability analysis of soil cut-slopes has been conducted by limit equilibrium method on Seep/w and finite element method on Slope/w.

• The Transactions of the Korean Institute of Electrical Engineers D
• /
• v.52 no.6
• /
• pp.372-377
• /
• 2003

Many of modem radars use modulated pulse repetition intervals for the purpose of anti-aliasing and ECCM. The interception, analysis and identification of radar signals is a major function of a radar intercept receiver. In this paper, we discuss the identification of pulse repetition intervals modulation of radar signals which is one of the major parameters for the analysis of radar. We proposed a new algorithm based on Markov models approach. This approach is shown to be reliable and robust to the missing pulses, as well as to require only relatively few pulse data.

• Journal of Electrical Engineering and Technology
• /
• v.1 no.1
• /
• pp.98-100
• /
• 2006

ZnO thin films were deposited at different repetition rates of 5 Hz and 10 Hz by pulsed laser deposition. X-ray diffraction (XRD) full widths at half maximum (FWHMs) of (002) ZnO peak in ZnO thin film deposited at 5 Hz and 10 Hz was 0.22 and $0.26^{\circ}$, respectively. The grain size of ZnO thin film deposited at 5 Hz was larger than that of 10 Hz. The variation of repetition rates did not have an effect on the optical property of ZnO thin films. The degradation of the crystalline quality and surface morphology in ZnO thin film deposited at 10 Hz resulted from supersaturation effect by decrease of time interval between a ZnO particle arriving on a substrate by laser shot and a ZnO particle arriving on a substrate by next laser shot.

• ETRI Journal
• /
• v.21 no.4
• /
• pp.29-40
• /
• 1999

In this paper, we show the robustness of a proposed system using both a frequency diversity and a time diversity effect when the channel assumptions are relaxed such that all sub-bands are not independent fading. We take time-repetition coding with interleaving such that the repetition code symbols are spaced sufficiently far apart to guarantee time diversity. We also incorporate offset multicarriers into a proposed multicarrier DS-CDMA system in a different way compared to that of [10] to reduce the total multiple access interference. When we take a convolutional encoder instead of a time-repetition encoder, and again use both time diversity and frequency offset, then we can obtain the significant performance gain.