• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.2
• /
• pp.121-126
• /
• 2004

This paper presents an SAR-data calibration technique using a well-calibrated scatterometer. At first a fully-polarimetric antenna pattern(magnitude and phase) of the antenna main-beam using a conducting sphere was measured. Then, this data were used to calibrate polarimetrically an auto-mounted network analyzer-based scatterometer system. This scatterometer system can be used to measure the accurate Mueller matrices of earth surfaces such as grass fields, rice fields and bare soil surfaces; i.e., the phase-difference parameters can be obtained as well as the radar scattering coefficients. If a polarimetrically calibrated scatterometer is operated at the same time with the SAR system, the scatterometer data can be used to correct the SAR data, especially the phase-difference parameters. It was found that the correction effect is remarkable for the degree of correlation ${\alpha}$, which is one of the phase-difference parameter, while the correction effect is negligible for the magnitude parameters(backscattering coefficients).

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.12
• /
• pp.1308-1315
• /
• 2009

A full-polarimetric scatterometer(HPS: Hongik Polarimetric Scatterometer) for X-band is designed, fabricated, and verified using the theoretically well-known point-targets in this paper. The X-band full-polarimetric scatterometer consists of an OMT(Orthogonal-Mode Transducer)+horn antenna, the angle control part for the OMT+horn antenna, a transmitter/receiver with a network analyzer and a frequency-conversion circuitry, and a movable support of these parts. We use an inclinometer sensor to control the vertical and horizontal incidence angles. The full polarimetric data can be obtained because of the polarization switches and the OMT. The accuracy of the scatterometer system is verified by measuring the polarimetric RCS(Radar Cross Section) of one of the theoretically well-known point-targets, i.e., a corner reflector.

• Proceedings of the KSRS Conference
• /
• 2002.10a
• /
• pp.621-626
• /
• 2002

A satellite scatterometer is a microwave radar sensor used to measure the backscattering at a sea surface. This instrument transmits radar pulses to the sea surface and measure the radar energy reflected back towards the source. Changes in wind velocity make sea surface roughness change and then affect on backscattered power. This gives us information of sea surface wind speed. Directions of wind vectors are acquired by multiple, collocated, and nearly simultaneous measurements. It should be noted that the scatterometer observes not the wind directly but the wind stress vector relative to the surface current. This suggests the possibility that the satellite scatterometer winds can include the effect of the surface current. This study shows the evidence that scatterometer measure surface wind stress, not surface winds and presents the velocity structure of oceanic warm and cold eddies.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2003.11a
• /
• pp.3-7
• /
• 2003

In this paper, radar scattering coefficients of earth surfaces such as grass fields, rice fields and bare soil surfaces are measured by using an auto-mounted network analyzer-based scatterometer system. The scatterometer system is calibrated both the magnitude and phase in order to obtain the accurate Mueller matrices of the earth surfaces. Then the accurate scattering matrices can be obtain from the Mueller matrices. The degree of correlation $\alpha$ is also obtained by this procedure and is used to correct AirSAR data which are not calibrated with phase variations.

• Proceedings of the KSRS Conference
• /
• 2007.10a
• /
• pp.633-636
• /
• 2007

The objective of this study is to measure backscattering coefficients of paddy rice using L, C, X-bands scatterometer system during a rice growth period. The measurement was conducted at an experimental field located in National Institute of Agricultural Science and Technology (NIAST), Suwon, Korea. The rice cultivar was a kind of Japonica type, called Chuchung. The scatterometer system consists of dual-polarimetric square horn antennas, HP8720D vector network analyzer (20MHz ${\sim}$ 20GHz), RF cables, and a personal computer that controls frequency, polarization and data storage. The scatterometer system is calibrated using a calibration kit (3.5mm, 85052D). The backscattering coefficients were calculated by applying radar equation for the measured at incidence angles between $20^{\circ}$ and $60^{\circ}$ for four polarization (HR, VV, HV, VH), respectively, and compared with rice growth data such as plant height, stem number, biomass, dry weight and LAI that were collected at time of each scatterometer measurement simultaneously.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.4
• /
• pp.408-416
• /
• 2010

A study on the calibration of an X-band HPS(Hongik Polarimetric Scatterometer) system for ground-based operation is presented in this paper. In order to calibrate the scatterometer system, the degree of its distortions are analyzed by comparison between theoretical- and measured-values using the theoretically well-known calibration targets such as a metal sphere, a trihedral corner reflector(CR) and a metal cylinder. The calibration works in the field conditions depend on the precise and stable measurements of those calibration target. we present a measurement technique, so-called, an automatic 2-D target-scanning technique, using the incidence-angle(${\xi}-$ and ${\phi}-$ directions) control of HPS system. Then, we used STCT(Single-Target Calibration Technique) and GCT(General Calibration Technique) to calibrate a distortion of the scatterometer system, and measured the polarimetric RCS(Radar Cross Section) and phase-difference of a trihedral-CR as a test-target to verify the accuracy of the calibration technique. Then, three different types(i.e., 10, 20, 30 cm) of trihedral-CR were used. we obtained the error ranges about ${\pm}1.0$dB, ${\pm}0.5$ dB in a polarimetric RCS and about $-20^{\circ}{\sim}0^{\circ}$ and ${\pm}5^{\circ}$ in the co-polarized phase-difference by using the GCT and STCT, respectively.

• Proceedings of the KSRS Conference
• /
• 2003.11a
• /
• pp.1002-1004
• /
• 2003

A ground-based, C-band full polarimetric mobile Scatterometer system has been developed in Malaysia with collaboration between Malaysian Centre for Remote Sensing (MACRES) and Multimedia University (MMU). The main purpose of this system is to measure and monitor backscattering coefficient, ${\sigma }^0$, for earth terrain such as paddy fields, forest and soil surfaces. This paper describes the preliminary results on radar backscatter measurement from paddy field using the mobile C-band Scatterometer system. The measurement campaign was conducted at Sungai Burung area in April 2003. Real time data were collected using four polarization modes (HH, HV, VV and VH), at various incidence angles ranging from 0$^0$ to 60$^0$. The measurement data show consistent results as compared to other reports, which verify the capability of this Scatterometer system as a useful tool for remote sensing.

• Proceedings of the KSRS Conference
• /
• 2004.10a
• /
• pp.61-63
• /
• 2004

The procurement of a mobile microwave scatterometer platform involved the consideration to ensure a mobile platform and equipment selected full-filled technical requirement and safety standard in Malaysia. Designing, and modification works involved engineering methodology in determining and selecting a suitable hydraulic telescopic boom that suit a selected mobile platform available locally. The mobile platform is a delivery system for microwave remote sensing microwave scatterometer and other accessories to any locations in Malaysia. Total loading to be carried by the mobile platform is 4500 kg and its overall weight must be 16,000 kg as recommended by hydraulic telescopic boom manufacturers. The telescopic boom will elevate microwave scatterometer system including the antenna to a maximum height of 27 m, and can also be rotated through $3600^{\circ}$. A mechanism is incorporated in the system to enable tracking or monitoring angular movement of the hydraulic telescopic boom when positioned towards predetermined target.

• Proceedings of the KSRS Conference
• /
• v.1
• /
• pp.135-137
• /
• 2006

HY-2, the China's satellite for oceanic dynamic environment measurement, is planed to be launched around 2010. The main payloads of HY-2 include a dual-frequency radar altimeter equipped with a three-band nadir-looking radiometer for atmospheric delay correction, a Ku-band radar scatterometer, and a five-band scanning radiometer. This presentation outlines the specifications, parameters, and design of the HY-2 radar altimeter and scatterometer.

• Proceedings of the KSRS Conference
• /
• v.1
• /
• pp.130-133
• /
• 2006

Three scatterometers will be launched by Europe, India, and China in the next few years and they will fly in tandem with QuikSCAT of the United States. The potential improvement in coverage will open up new operational and research applications.