• Korean Journal of Food Science and Technology
• /
• v.9 no.1
• /
• pp.68-72
• /
• 1977

Seed separation out of fresh red pepper by impact methods was effective but impossible to separate over 45% of seed. For the increase of seed separation, dehydration effect was studied with the slices of pepper. Heat deformation during the course of drying at hot air of 0. 61m/sec velocity at temperature of $65^{\circ}C$, increased the separation up to 93% with a halfcut pepper. Seed separation was remarkably different upon the location of cut, but it was completed prio tothe completion of drying in every cutting orientations. From these results a simultaneous seed separation and drying operation techniques is successfully developed.

• Membrane Journal
• /
• v.24 no.5
• /
• pp.375-385
• /
• 2014

NaA zeolite/${\alpha}$-alumina composite membranes were hydrothermally synthesized at $100^{\circ}C$ for 24 hr by using nanosize seed of 100 nm in diameter and an ${\alpha}$-alumina support of $0.1{\mu}m$ in pore diameter, and then effect of seed coating layer on the microstructure of NaA zeolite separation layer was systematically investigated. In cases when nanosize seed was coated with a monolayer, increment in seed coverage induced small grained and thick NaA zeolite separation layer. On the other hand, in case when nanosize seed was coated with a multilayer, much small grained and thick separation layer was formed. It was clear that an uniform monolayer seed coating is required to grow hydrothermally a thin and defect-free NaA zeolite separation layer. In the present study, it was clearly announced that seed coating layer is a key factor to determine the microstructure of NaA zeolite layer, secondary grown on a porous support.

• Korean Journal of Food Science and Technology
• /
• v.9 no.1
• /
• pp.61-67
• /
• 1977

Seed separation from half-cut red pepper were investigated with free falling, up-and-down shaking and rotating collision methods. The separation rates were related with impact appiied and the rotating case was distinguished from the other two methods. Beside the impact effect, velocity of the pod and tumbling factors were involved. Momentum effectiveness of seed separation were calculated as $2.50{\times}10^{-6}$, $2.09{\times}10^{-6}$, and $3.94{\times}10^{-8}$ for free falling, shaking and rotating method on the same velocity basis, respectively. The tendency of separation rate was similar to that of red pepper drying rate against time.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.60 no.1
• /
• pp.29-32
• /
• 2015

Two-dimensional electrophoresis (2-DE) was executed to separate the seed storage proteins from the buckwheat. The proteins extracted from the whole seed proteins were better separated and observed in the use of lysis buffer. Using this method, the highly reproducible isoelectric focusing (IEF) can be obtained from polyacrylamide gels, and IEF from the polyacrylamide gel at all the possible pH range (5.0-8.0) was more easily separated than IPG (immobilized pH gradient) gels. The polyacrylamide gels in the first dimension in 2-DE was used to separate and identify a number of whole seed proteins in the proteome analysis. In this new apparatus using 2-DE, 27cm in length of plate coated with polyacrylamide gel was used and the experiment was further investigated under the various conditions.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.50 no.2
• /
• pp.73-78
• /
• 2005

Demand for the domestic hairy vetch seed production will be increased with the increasing interest of environment-friendly agriculture in Korea. This study was conducted during from 2000 fall to 2003 spring at upland field of National Institute of Crop Science in Suwon, Korea to compare wheat and triticale (TC) as stake crop of hairy vetch (HV), and to know proper seeding rates and ratios between TC and HV for the maximum HV seed production. As supporting crop of HV, TC was superior to wheat at the points of higher HV seed yield, stronger TC stalk for supporting, consistence of ripening stage of two seeds. In seeding method, row seeding was superior to broadcast seeding at the points of less lodging and higher HV seed yield. HV seed yield decreased with the increase of TC seeding rate in mixture cropping (row seeding), particularly at TC seeding rates over 5kg/10a. HV seed yield increased with the increase of HV seeding rate at the condition of TC seeding rates under 5kg/10a in spite of higher lodging of mixed crops at higher HV seeding rate due to higher HV aboveground dry matter. Maximum HV seed yield was obtained at TC seeding rate of $1\~1.5kg/10a$ as indicating HV seed yield 176kg/l0a (CV. Madison) at seeding rate of TC 1kg/10a + HV 2 kg/10a in 2001, and HV seed yield 96kg/10a (CV. Common) at seeding rate of TC 1.5kg/10a + HV 4.5kg/10a in 2003. Use of all-purpose combine harvester for harvesting and appliance for separation of mixed seeds using centrifugal force, which are prerequisite for HV seed production, was excellent in the simultaneous seeds production system of HV and TC.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.29 no.11
• /
• pp.702-706
• /
• 2016

We demonstrated that self-separation FS-GaN (freestanding-GaN) was grown on MELO (maskless epitaxially lateral overgrowth) GaN template by horizontal HVPE (hydride vapor phase epitaxy). Before thick GaN grwoth, MELO GaN template was grown on patterned GaN template by MOCVD (metal organic chemical vapor deposition). The laterally overgrown GaN would consist of a continuous well coalesced layer. The mixed TDD (threading dislocation density) of seed and wing region were $8{\times}10^8cm^{-2}$ and $7{\times}10^7cm^{-2}$, respectively. After thick GaN grown by HVPE, the self-separation between thick GaN and sapphire substrate was generated at seed region. The regions of self-separation for FS-GaN and sapphire were observed by FE-SEM. Moreover, Raman results indicated that the compressive strain of seed and wing regions at FS-GaN substrate were slightly released compared to that of thick GaN grown on conventional GaN template. The optical properties of the FS-GaN substrate were examined by using PL (photoluminescence). The PL exhibited that donor bound exciton and donor acceptor pair were observed at low temperature. The effects on optical and structural properties of FS-GaN substrate have been discussed in detail.

• Membrane Journal
• /
• v.25 no.5
• /
• pp.422-430
• /
• 2015

The present study announces that the pH value of seed coating solution makes a significant effect on the microstructure of silicalite-1 zeolite layer formed on ${\alpha}$-alumina support. Seed with an average diameter of 75 nm was dispersed in ethanol to prepare three kinds of seed coating solutions with different pH values, and dip-coated on the support. The pH value was controlled to be 2.2, 7.0, and 9.3, respectively. In the secondary growth process, pH 7 seed solution resulted an uniform, 3 to $4{\mu}m$ thick, completely covered, and 100 nm grained silicalite-1 zeolite separation layer. The uniformity and completeness were explained by a uniform, closely packed, multi-layered, and completely covered seed coating in the pH 7 condition. In the condition, ${\alpha}$-alumina support and seed are oppositely charged: support is positively charged (8.4 mV) and seed, negatively (-1.7 mV). The opposite charging induced a strong electrostatic attraction between seed and support, which made the good seed coating state. On the other hand, pH 2.2 and pH 9.3 seed solutions resulted non-uniform, partially covered, and around $1{\mu}m$ grained zeolite separation layer, since seed and support are the same sign charged in the conditions. The same sign charging induced a strong electrostatic repulsion between seed and support which caused a low coverage of seed. It could be concluded that the pH value of seed coating solution is a key parameter to determine the microstructure of silicalite-1 zeolite separation layer.

• Analytical Science and Technology
• /
• v.7 no.3
• /
• pp.403-411
• /
• 1994

To isolate, purity and identify of bioactive compounds involved in alfalfa allelopathy and/or autotoxicity, experiment was conducted. Isolation and separation procedures used from an 80% methanol extract of fresh alfalfa leaves(1kg), silica gel thin layer chromatography(TLC), followed by Droplet Counter Current Chromatography(DCCC). Preliminary identification was examined by high preformance lipid chromatography(HPLC). Four phenolic compound, salicylic acid, scopoletin, rutin, and quercetin, were identified and identified all compounds were phytotoxic to alfalfa seed germination and seedling growth. Among these compounds, quercetin treatment($10^{-3}M$) was most inhibitory to alfalfa seed germination and seedling growth. These compounds may be, at least in part, involved autotoxicity and allelopathy.

• Asian Journal of Turfgrass Science
• /
• v.18 no.1
• /
• pp.29-36
• /
• 2004

The efficient refinement of seed is required to reduce the cost and labor input in artificial propagation of wild plant. This study was carried out to develop methods for collecting and refining tiny seeds from wild plants. For obtaining Phragmites communis seeds, the inflorescence was cut into small fragments using a Straw Cutter and subsequently detached pappus hairs from seed coat by Hammer Mill. The primary refined seeds were passed 1.0 mm sieve. The screened seeds were subjected to Seed Blower with wind speed of 0.25 mㆍsec-1 to collected intact and well-ripen seeds. The seeds of Imperata cylindrica were refined as follows. Inflorescences were cut using a Straw Cutter first. The pappus was removed from cut fragments using a Hammer Mill and subsequently subjected to Seed Scarifier at 500rpm for 60 sec. for further separation. The separated seeds were passed 1.0 mm screen and collected after blowing with Seed Blower of wind speed of 0.15 mㆍsec-1. When the amount of seed was too little to refine with Seed Scarifier and Blower, the procedure was slightly modified from the procedure described above. The crude seed mixture obtained from Hammer Mill step was hand-refined roughly and then immersed into cone. (95%) sulfuric acid for 2 min. and collected floating portion after dilution of sulfuric acid solution 100 times with tap water. The collected seeds were dried and passed 0.149 mm sieve. During seed refining process using mechanical or sulfuric acid treatments, a small portion of damaged seed were evolved, however, the amount was not noticeable as compared to the total amount of collected seeds. Because the germination percentages between hand-refined seeds and seeds refined by above methods were not statistically different, the developed procedures for refining tiny seed of wild plants are helpful to reduce the cost and labor input in artificial propagation of two species.

• Applied Microscopy
• /
• v.42 no.4
• /
• pp.194-199
• /
• 2012

The anatomy and morphology of seeds from 10 Hawaiian Portulaca taxa were examined to explore patterns of variation among the taxa, and to evaluate their phylogenetic relationships. Features of seeds were assessed employing microtechnique procedures, statistical analysis, and scanning electron microscopy (SEM). Anatomically, the orientation of embryo was consistent across taxa, and all seeds examined had central nutritive tissue and integuments comprising the peripheral embryo. Seeds were generally small, circular to ovoid in shape, and either smooth or rough-surfaced, with tubercules. Variation in seed size was noted, although minimal within small seeded group. The size of seeds ranged from 0.50~1.26 mm in length, and 0.55~1.34 mm in width, with similar weights. Seeds were distinguished by the sculpture and arrangement of the testa epidermis and the way in which their stellulate-tessellate cells uniquely fit together. Using a multiple range test (ANOVA), two groups were established by seed characteristics. The SEM also demonstrated morphological differences in testa sculpturing. The results obtained confirm the usefulness of seed characteristics in the identification of the species examined, and furthermore, allow for the separation of the Hawaiian Portulaca into two groups.