• Korean Journal of Soil Science and Fertilizer
• /
• v.44 no.4
• /
• pp.545-550
• /
• 2011

Urea intercalated into montmorillonite (MT) exhibits remarkably enhanced N use efficiency, maintaining its fast effectiveness. This study dealt with the release property of urea from metal-urea-clay hybrid with MT (MUCH) under continuous-flow conditions and the cumulative impacts of its successive application on physicochemical properties of soils. Releases of urea were completed within 4 hrs under continuous-flow condition regardless of the types and the leaching solutions. However, urea release property was significantly affected by both the form of fertilizer and the presence of electrolytes in solution. The fast release property of urea from MUCH in continuous-flow condition was not significantly affected by soil properties such as soil pH and soil texture. In addition, its successive application did not lead to any noticeable change in soil physicochemical properties, water stable aggregate rate, water holding capacity and cation exchange capacity in both sandy loam and clay loam soils. Therefore, this study strongly supported that urea intercalated into MT could be applied as fast-effective N fertilizer, in particular for additional N supply.

• KIEAE Journal
• /
• v.9 no.2
• /
• pp.65-71
• /
• 2009

Results from tests for what mixing rate of soil and sand is proper for the rammed earth and for how much additives are optimum are as under. 1) In the test to evaluate what mixing rate of soil and sand is desirable, peptizing property and surface sticking rate are found similar in its degree, but compression strength is found most stable when the ratio of soil and sand mixing shows 30:70 which indicates the best mixing rate of soil and sand. 2) In a test to add hydrated lime, compression strength, peptizing property, and surface sticking rate are found best when the mixing rate of soil and sand shows 23:7. 3) In a test to add sea weeds, the peptizing property goes down at 75% of sea weeds input a little bit more than at 100%, but compression strength shows best at 75% which is thought to be the best rate. 4) In a drop test, more soil powder mixed, the sticking strength gets better and more sands are contained, the sticking strength gets far worse to be scattered in powder type. 5) As concluding all results mentioned in the above item, the most desirable mixing rate of soil, sand, and hydrated lime is found to be 23:7:70 for the rammed earth where compression strength, peptizing property, and surface sticking rate are best.

• Proceedings of the KIEE Conference
• /
• 2002.07a
• /
• pp.22-24
• /
• 2002

This paper introduces the real-time soil thermal property analyzer and temperature measuring system which is combined with radio telecommunication technique. To measure the thermal parameters in real-time, the radio telecommunication technique are used the personal communication service (PCS) which is in the world-wide serviced commercially firstly by CDMA. The thermal property analyzer has an ability of measuring thermal resistivity, thermal diffusivity and thermal stability. To estimate the soil thermal properties, the curve fitting algorithm by means of the least square method are used. TCP/IP protocol and MTM are used to install the real-time soil thermal property and temperature measurement system at multiple locations along routes of the underground power cables and to reduce the cost of telecommunication.

• Proceedings of the Korean Society of Plant Pathology Conference
• /
• 2002.11a
• /
• pp.107.2-108
• /
• 2002

Barley Yellow Mosaic Virus(BaYMV) is responsible for ane of the most improtant disease in malting Barley in Korea. It is transcitted by soil borne fungus, Polymyza graminis To estimate the occurrence pattern of BaYMV by the physio-chemical property of soil collected from farmer's sield, this study was conducted. The rate of didsease occurrence to BaYMV investigated at 19 spots of 10th regions. The sample soil was collected by 20 pots among an ifected field and analyzed th soil characters in 2002. The rate of disease occurrence to BaYMV was about 79%,60%,65% in Sacheon, Kosung and Hadong areas, respectively, which is malting Barley growing regions but Pohang, Yeongduk, Euesung, Gunwee, which are growing Covered Barley doesn't infected BaYMV. The tested of RT-PCR was showed that the BaYMV, BMMV.SBWMV. were identified in Milyang but the others regions was infected only to BaYMV. The physio-chemical property of soil collected from infected soil show various range such as pH(4.98~8.05), EC(0.44~2.7%),OM(1.61~6.85), P2O5958~519), K(0.22~1.82), Ca(2.3~9.7), Mg(0.5~2.6), Na(0.14~0.43) The correlation coefficient between physio-chemical property fo the infected soil and infection rate shows significant to pH at 5% level. Although OM and Ca were high scores, it doesn't significant at 5% but it need to be more study in future.

• Asian Journal of Turfgrass Science
• /
• v.10 no.1
• /
• pp.31-40
• /
• 1996

The mechanical expresion provides for the use of Soil property reserves and permanent protec-tion or improvement of soil resources in accordance with measurable standards. If the functions I (initial soil property), E (soil erosion), R (soil renewal), and M. (minimum allowable value) are assumed to be integrable in region A, erosion tolerance over a region is leaded to ${\int}_A{\int}I(m, cl, re, ch, b)dA-{\int}_A{\int}{\{\int}_{to}^{\infty}[E(w, re, c, re, ch, b, t)-R(m, ch, re, b, t)]dt}\dA{\geqq}{\int}_A{\int}M_i(m, cl, re, ch, b)dA$ were variable factors are m=parent material of soil, cl=climate, re=relief or topography, ch=soil characteristics, r=rain or water, w=wind, b=biota, and t=time.

• Journal of Biosystems Engineering
• /
• v.33 no.4
• /
• pp.260-268
• /
• 2008

Optical diffuse reflectance sensing has potential for rapid and reliable on-site estimation of soil properties. For good results, proper calibration to measured soil properties is required. One issue is whether it is necessary to develop calibrations using samples from the specific area or areas (e.g., field, soil series) in which the sensor will be applied, or whether a general "factory" calibration is sufficient. A further question is if specific calibration is required, how many sample points are needed. In this study, these issues were addressed using data from 42 paddy fields representing 14 distinct soil series accounting for 74% of the total Korean paddy field area. Partial least squares (PLS) regression was used to develop calibrations between soil properties and reflectance spectra. Model evaluation was based on coefficient of determination ($R^2$) root mean square error of prediction (RMSEP), and RPD, the ratio of standard deviation to RMSEP. When sample data from a soil series were included in the calibration stage (full information calibration), RPD values of prediction models were increased by 0.03 to 3.32, compared with results from calibration models not including data from the test soil series (calibration without site-specific information). Higher $R^2$ values were also obtained in most cases. Including some samples from the test soil series (hybrid calibration) generally increased RPD rapidly up to a certain number of sample points. A large portion of the potential improvement could be obtained by adding about 8 to 22 points, depending on the soil properties to be estimated, where the numbers were 10 to 18 for pH, 18-22 for EC, and 8 to 22 for total C. These results provide guidance on sampling and calibration requirements for NIR soil property estimation.

• Journal of Biosystems Engineering
• /
• v.33 no.6
• /
• pp.416-422
• /
• 2008

This study was performed to design and construct a digital soil shear stress sensor in order to replace the conventional devices for measuring soil shear property. The developed digital shear stress measuring device can store measured data with GPS position information as a vector format into a computer. Based on the experiments at various field conditions, the measuring characteristic of the device was quite similar to that of a conventional device, SR-2 that has been a major tool to measure the soil shear property. It was concluded that the digital shear stress measuring device was an effective and comprehensive sensor for measuring soil shear property.

• Korean Journal of Agricultural Science
• /
• v.49 no.4
• /
• pp.667-676
• /
• 2022

The soil physical and chemical properties are the main factors that influence plant productivity and soil fertility. Since 1999, South Korea has been conducting a survey on changes in the agricultural environment survey every four years. The purpose of the present study is to monitor the physical and chemical properties of soil in Chungcheongbuk-do. Soil samples were collected from the exact sites of the aforementioned environment survey, and land use and cultivated crops were also investigated. From a Pearson correlation analysis, it was found that the total carbon contents were most negatively affected by the soil depth. The bulk density of soil increased up to a depth of 40 cm but decreased to a depth of 60 cm. The porosity and moisture of soil generally decreased, but the porosity increased at a depth of 50 - 60 cm. Chemical properties of soil gradually decreased with an increase of the soil depth from 0 to 70 cm, but little change was observed in soil pH with soil depth. In addition, the organic matter contents of the soil at a depth of 30 cm or more were below the optimal range. The soil of Chungcheongbuk-do thus requires organic matter application as a whole, and correction of items that are partially out of the optimal range is necessary.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.8 no.1
• /
• pp.49-55
• /
• 2020

In this study, the surface temperature of the roof green system using ALSRBA(Artificial Lightweight Soil Recycled with Bottom Ash) was measured in each season and the thermal property of the ALSRBA was investigated. As a result, it was certified that ALSBRA has superior thermal property than the usual artificial soil. In addition, The daily temperature range in each season was measured to investigate the thermal isolation property of EUS(Existing Unit System) and DUS(Developed Unit System). The result showed that the thermal isolation effect of EUS was lower than that of SPSS(Site-Place-Soil System), but thermal isolation effect of DUS was similar to that of SPSS because DUS has continuous ALSBRA layer by removing unit barrier.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.40 no.4
• /
• pp.85-93
• /
• 1998

In the 2nd year study of a 5 year project to evaluate the soil quality and develop the best management practices for mountaineous soils, 11 runoff plots were treated and monitored with respect to physical property of the soil, runoff and sediment discharge, and the following results were obtained. 1. Bulk density and porosity did not show any siginificant difference between experimental treatments. 2. Runoff was basically dependent on the soil's physical property and tillage. Up-and-down plots showed the highest runoff while contour plots the lowest runoff. 3. Sediment yield in the mountaineous soils was directly related to tillage and residue cover. Residue covered plots showed the lowest sediment yield and up-and-down plots the highest sediment yield. And it is recommended that the best management practices using till_age and residue cover for the mountaineous soils must be developed to protect soil quality and maintain agricultural productivity.