• Journal of Environmental Science International
• /
• v.15 no.3
• /
• pp.211-219
• /
• 2006

An experimental study on the removal of VOCs gas using a biomembrane reactor were carried out at various inlet gas concentration, specific loading rate, retention time and gas flow rate of volume. The variations of efficiency and various parameters, which are relevant to gas removal, with mixing of soluble gas and without have been discussed. More than 95% of the toluene and methanol present in the feed was successfully removed in each study. The elimination of methanol with mixture of soluble compound of about 300 mg/h corresponds to a portion of 21% if there is a feed stream of 1400 mg/h. On the contrary the maximum efficiency of about 72% of toluene was reached. This is to be rated as a treatment of sorption that the limiting factor of the dismantling speed could be represented by this difficult degradable component. Nevertheless the elimination capacities for this reactor for toluene were on a very high level. For substances which show a very high solubility in silicon rubber an advantage of a bio membrane is clearly shown. Therefore a similarly good result is expected for n-hexane, because of its relatively good permeability which was distinguished during permeation experiments.

• Carbon letters
• /
• v.28
• /
• pp.38-46
• /
• 2018

Modified pitch A (MPA) and modified pitch B (MPB) were prepared by oxidative polymerization and thermal polycondensation reaction with refined pitch as the raw material, respectively. The toluene soluble components (TS-1 and TS-2) were obtained by solvent extraction from MPA and MPB, separately. The Flynn-Wall-Ozawa method and Kissinger-Akahira-Sunose method were used to calculate the pyrolysis activation energy of TS. The Satava-Sestak method was used to investigate the pyrolysis kinetic parameters of TS. Moreover, the optical microstructure of the thermal conversion products (TS-1-P and TS-2-P) by calcination shows that TS-1-P has more contents of mosaic structure and lower contents of fine fiber structure than TS-2-P. The research result obtained by a combination of X-ray diffraction and the curve-fitting method revealed that the ratios of ordered carbon crystallite (Ig) in TS-1-P and TS-2-P were 0.3793 and 0.4417, respectively. The distributions of carbon crystallite on TS-1-P and TS-2-P were calculated by Raman spectrum and curve-fitting analysis. They show that the thermal conversion product of TS-2 has a better graphite crystallite structure than TS-1.

• Bulletin of the Korean Chemical Society
• /
• v.29 no.1
• /
• pp.135-138
• /
• 2008

Two bicarbazyl-containing fluorene copolymers, PFEBCz (95/5) and PFEBCz (75/25), were synthesized for white light electroluminescence from a single emitting polymer. All synthesized polymers were soluble in common organic solvents such as chloroform and toluene. The weight-average molecular weights (Mw) of the PFEBCz (95/5) and PFEBCz (75/25) copolymers were found to be 11,000 and 5,700 with polydispersity indices 1.4 and 1.8. The EL spectrum of the PFEBCz (75/25) device showed bright white-light emission with CIE coordinates of (0.32, 0.34) at 1000 cd/m2, which is very close to that for pure white (0.33, 0.33). This white emission may have been due to strong excimer formation between the bicarbazyl and fluorene polymer backbone. The device exhibited a maximum brightness of 3400 cd/m2 with a maximum efficiency of 0.2 cd/A.

• Journal of Korea Soil Environment Society
• /
• v.2 no.1
• /
• pp.83-90
• /
• 1997

Aiming at the treatment of large volumes of gas with a low concentration of poorly water soluble VOC(Volatile Organic Compound), a new system is proposed: the combination absorption tower/bioreactor. In the scrubber part of the bioscrubbing system, the contaminating compounds are absorbed in a aqueous phase. The contaminated scrubbing liquid is transported to the bioreactor, where the compounds are biodegraded by aerobic microorganisms (mainly to carbon dioxide, water, and biomass). In this study, separation of a volatile organic compound(VOC) out of a waste gas stream has been carried out using a re-cyclable high boiling point extrant(HBE). The liquid stream containing a high boiling point entrant(HBE) scrubs the gas stream in a direct gas-liquid countercurrent contacting operation in a packed tower for the removal of said component from the gaseous stream. A packed-bed column using Pall Ring was set up in order to simulate practical conditions for the scrubbing tower. The liquid stream transported to the bioreactor is recovered and recycled to the scrubber. The model gas, which contained 400 mg/$\textrm{m}^3$ of toluene, at a rate of 100 L/min, flowed into the packed column where the scrubbing liquid trickled over the packing in countercurrent to the rising gas at 10~15L/min. The bioscrubber designed for large volume air streams containing VOCs showed removal efficiency up to 80% in an optimum operating conditions during the tests fer removing toluene from an air stream by scrubbing the air stream with HBE.

• Food Science of Animal Resources
• /
• v.30 no.3
• /
• pp.373-384
• /
• 2010

The present paper describes the effect of cooking temperature on objective meat qualities and volatile components in beef longissimus lumborum. Twenty samples of lumbar vertebrae longissimus muscle from Australian Black Angus (grain-fed and chiller aged for 29 d) were screened. Samples were cooked at 50, 70 or $90^{\circ}C$ in a pre-heated water bath for 1 h and uncooked raw samples were used as control. The results revealed that elevating the heating temperature from 50 to $90^{\circ}C$ led to a significant (p<0.05) increase in WB-shear force, total energy required for WB-shear force, cooking loss, pH and soluble collagen content, whereas a significant (p<0.05) linear decrease in protein solubility was observed. The results also revealed that the WB-shear force at $70^{\circ}C$ was significantly (p<0.05) lower than that observed at $50^{\circ}C$ and $90^{\circ}C$. However, the effect of temperature on cooking loss and protein solubility was notably (p<0.05) higher at $70^{\circ}C$. The detectable volatile components were mostly produced from fat oxidation, and temperature effects on the generation of volatile components were significantly (p<0.05) greater for aldehydes (hexanal, benzaldehyde, nonanal and octanal) than for ketones and hydrocarbons (hexane, benzene, decan, toluene and 3-methylnonane).