• Journal of Fisheries and Marine Sciences Education
• /
• v.25 no.2
• /
• pp.301-306
• /
• 2013

In this paper, cycle performance analysis of two-stage compression and two-stage expansion refrigeration system using alternative freon refrigerants is presented to offer the basic design data for the operating parameters of the system. Alternative freon refrigerant for freon refrigerant R22 were used as working fluids in this study. The operating parameters considered in this study included evaporation temperature, condensation temperature, subcooling degree, superheating degree, and mass flow rate ratio of inter-cooler. The main results were summarized as follows : The COP of two-stage compression and two-stage expansion refrigeration system increases with the increasing subcooling degree and mass flow rate ratio of inter-cooler, but decreases with the increasing evaporating temperature, condensing temperature and superheating degree. Therefore, subcooling degree, mass flow rate ratio of inter-cooler of two-stage compression and two-stage expansion refrigeration system using alternative freon refrigerants have an effect on COP of this system.

• International Journal of Air-Conditioning and Refrigeration
• /
• v.17 no.3
• /
• pp.107-113
• /
• 2009

The objective of this study is to investigate performance characteristics of a household refrigerator using a two-stage compression cycle. The performance of the two-stage compression cycle was measured by varying the compressor speed, condensing temperature, and evaporating temperature. The COP of the two-stage compression cycle was analyzed and then compared with that of the single-stage compression cycle. The optimum combination of compressor speeds for a low- and a high-stage was determined. The COP of the two-stage compression cycle using a PTC (parallel two-stage compression) method was 5.85% higher than that of a STC (serial two-stage compression) method at optimum operating conditions.

• Communications for Statistical Applications and Methods
• /
• v.26 no.2
• /
• pp.163-173
• /
• 2019

Simon's two-stage designs are frequently used in phase II single-arm trials for efficacy studies. A concern of safety studies is too many patients who experience an adverse event. We show that Simon's two-stage designs for efficacy studies can be similarly used to design a two-stage safety study by modifying some of the design parameters. Given the type I and II error rates and the proportion of adverse events experienced in the first stage cohort, we prescribe a procedure whether to terminate the trial or proceed with a stage 2 trial by recruiting additional patients. We study the relationship between a two-stage design with a safety endpoint and an efficacy endpoint as well as use simulation studies to ascertain their properties. We provide a real-life application and a free R package gen2stage to facilitate direct use of two-stage designs in a safety study.

• Journal of Power Electronics
• /
• v.4 no.4
• /
• pp.197-204
• /
• 2004

Two-stage Power-Factor-Correction (PFC) converters are the most common circuits for drawing sinusoidal and in phase current waveforms from an ac source with a good regulated output voltage. The first stage is a boost PFC converter with average-current-mode control for achieving the near-unity power factor and the second stage is a forward converter with voltage-mode control to regulate the output voltage. Stability analysis and design methods of two-stage PFC converters have previously been discussed using linear models. Recently, new nonlinear phenomena have been detected in pre-regulator boost PFC circuits and a new nonlinear model has been proposed for pre-regulated PFC converters. Therefore, investigation of two-stage PFC converters from the nonlinear viewpoint becomes important because the second stage DC/DC converter adds more complexity to the circuit. So, this paper introduces a study of the stability of two-stage PFC converters. A novel nonlinear model of two-stage PFC converters is proposed. Then, a stability analysis is made based upon this nonlinear model. The high correspondence between the simulated and experimental results confirms our analysis.

• International Commerce and Information Review
• /
• v.8 no.1
• /
• pp.371-398
• /
• 2006

Gold prices are rising around the world in all major currencies. This is a telltale sign of a Stage Two gold bull where gold decouples from the US dollar. In this study, We analysed a confluence of factors seem to be feeding gold's gains and the typical shape of a secular gold bull---gold bulls' three stages. Stages one, two, and three of a secular gold bull are defined by the major changes. Each stage, considered in turn, makes perfect sense when described in terms of global investor demand. Since Stage One is currency-devaluation driven, the young gold bull is most noticeable in terms of the dominant eroding currency. Now after three or four years of stage one, Stage Two arrives. Stage Two marks a momentous event when gold decouples from the local-currency devaluation. In the case of our gold bull today, Stage Two will be here when gold starts consistently rising faster than the dollar is able to fall. After five or so years of Stage Two gains, gold has a chance at going ballistic in stage three. Stage Three is only ignited if the general public around the world starts growing enamored with gold investing. In summary, the first stage being when insiders and professionals invest in the market. The second stage is when the general public and financial media recognizes that the bull market is real. The third stage is the mania stage when people feel that not only is the bull market real, but it is a must own situation. Through the study we found that gold is entering it now.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.11 no.3
• /
• pp.422-430
• /
• 1999

This paper concerns the study of a two-stage absorption heat pump cycle to utilize treated sewage. This two-stage cycle consists of coupling double-effect with parallel or series flow type and single effect cycle so that the first stage absorber and condenser produces hot water to evaporate refrigerant in the evaporator of the second stage. The effects of operating variables such as absorber temperature on the coefficient of performance have been studied for two-stage absorption heat pump cycle. The working fluid is lithium bromide and water solution. The efficiency of the two-stage absorption heat pump cycle has been studied and simulation results show that higher coefficient of performance could be obtained for the first stage with parallel flow type. The optimum ratio of solution distribution can be shown by considering the COP, the crystallization of solution and the generator temperature.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.28 no.1
• /
• pp.1-8
• /
• 2014

The conventional Three-Stage electronic ballast is stable, but Two-Stage electronic ballast has been researching because of efficiency. Three-Stage electronic ballast is consisted of PFC circuit, buck converter, and inverter circuit, but Two-stage is consisted of PFC circuit, Buck-Inverter full bridge circuit. The Buck-Inverter full bridge inverter consists of two half bridge inverters for low frequency switching, and high frequency switching. In the case of street lamp it is far from a lamp to a ballast, the conventional pulsed high voltage ignitor can not turn on the HID lamps because of reduction of ignition voltage. Therefore, it needs to do the research on a resonant ignition to turn on the HID lamps. Therefore, in the Two-Stage electronic ballast which has the resonant tank for ignition, the transient resonant current because of low frequency changing is analyzed, the novel algorithm is proposed to resuce the transient current.

• Journal of Power System Engineering
• /
• v.13 no.6
• /
• pp.70-75
• /
• 2009

In this paper, cycle performance analysis of R744($CO_2$) two-stage compression and one-stage expansion refrigeration system is presented to offer the basic design data for the operating parameters of the system. The operating parameters considered in this study include superheating degree, compressor efficiency, gas cooling pressure, mass flowrate ratio, outlet temperature of gas cooler and evaporating temperature in the carbon dioxide two-stage refrigeration cycle. The main results were summarized as follows : The cooling capacity of two-stage compression and one-stage expansion refrigeration system increases with the increasing superheating degree, compressor efficiency and gas cooling pressure, but decreases with the increasing mass flowrate ratio and evaporating temperature. The compression work of two-stage compression and one-stage expansion refrigeration system increases with the increasing superheating degree, outlet temperature of gas cooler, gas cooling pressure and evaporating temperature, but decreases with the increasing compressor efficiency and mass flowrate ratio. The COP of two-stage compression and one-stage expansion refrigeration system increases with the increasing compressor efficiency, but decreases with the increasing superheating degree, gas cooling pressure, mass flowrate ratio and evaporating temperature. Therefore, superheating degree, compressor efficiency, gas cooling pressure, mass flowrate ratio, outlet temperature of gas cooler and evaporating temperature of R744($CO_2$) two-stage compression and one-stage expansion refrigeration system have an effect on the cooling capacity, compressor work and COP of this system.

• Microbiology and Biotechnology Letters
• /
• v.20 no.6
• /
• pp.663-667
• /
• 1992

The production of vinegar containing 16.0-18.0% of acetic acid was examined in two stage fermentation consisting of semi-continuous and fed-batch type. The optimum conditions were obtained when the fermentation was carried out at agitation of 600 rpm, aeration of 0.1 vvm and temperature of $30^{\circ}C$. The initial and residual ethanol concentration in 1st stage were $50.0g/{\ell}$ and $5.0g/{\ell}$, respectively, and the ethanol concentration in 2nd stage was maintained from 5.0 to $10.0g/{\ell}$. The maximum productivity was 3.3 gll-hr and the acidity was 17.6% after the two days of acetic acid fermentation.

• Journal of the Korean Data and Information Science Society
• /
• v.23 no.6
• /
• pp.1279-1287
• /
• 2012

We particularly emphasized how to determine the number of replications with sequential and multistage procedures. So, the t-test is used to achieve some predetermined level of accuracy efficiently with loss function in the case of normal, chi-squared, an exponential distributions. We provided that the relevance of procedures are sequential procedure, two-stage procedure, modified two-stage procedure, three-stage procedure and accelerated sequential procedure. Monte Carlo simulation is carried out to obtain the stopping sample size that minimizes the risk.