• Wind and Structures
• /
• v.35 no.5
• /
• pp.309-322
• /
• 2022

Due to the complex terrain around high-speed railways, the windbreaks were established along different landforms, resulting in irregular windbreak transition regions between different subgrade infrastructures (flat ground, cutting, embankment, etc). In this paper, the effect of a windbreak transition on the wind flow around railways subjected to crosswinds was studied. Wind tunnel testing was conducted to study the wind speed change around a windbreak transition on flat ground with a uniform wind speed inflow, and the collected data were used to validate a numerical simulation based on a detached eddy simulation method. The validated numerical method was then used to investigate the effect of the windbreak transition from the flat ground to cutting (the "cutting" is a railway subgrade type formed by digging down from the original ground) for three different wind incidence angles of 90°, 75°, and 105°. The deterioration mechanism of the flow fields and the reasons behind the occurrence of the peak wind velocities were explained in detail. The results showed that for the windbreak transition on flat ground, the impact was small. For the transition from the flat ground to the cutting, the influence was relatively large. The significant increase in the wind speeds was due to the right-angle structure of the windbreak transition, which resulted in sudden changes of the wind velocity as well as the direction. In addition, the height mismatch in the transition region worsened the protective effect of a typical windbreak.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.15 no.6
• /
• pp.29-41
• /
• 2012

This study was conducted in Ningxia Hui autonomous region, located at southern part of Mu Us sand land in China. To investigate relationships between windbreak effect and installation cost of sand barriers, plastic net is utilized by using four kind of heights (0.2, 0.3, 0.4 and 0.5m) and four kind of porosities (20, 30, 50 and 70%). These heights and porosities are measured for estimating distances for effective windbreak. It is shown that porosity and the distance have a positive relationship at same heights and porosity on ground indicates a constant figure when height reaches a certain level, regardless of the porosity. This implies that there is a difference of level of windbreak with different porosities; however, distance of windbreak effect is same at the same height of sand barrier. As a result of comparison between porosity of sand barrier on the ground and installation cost in each sand barrier with various heights and porosities (16 combinations), 0.4m and 0.5m height sand barriers describe highest economical efficiency. Within two variables, we concluded that height has a higher impact on windbreak effect than porosity.

• Journal of ILASS-Korea
• /
• v.19 no.3
• /
• pp.136-141
• /
• 2014

This study reports numerically the characteristics of dust scattering around the coal storage pile yards, substantially affected by the windbreak wall height. The dust scattering is closely associated with the frictional effect of wind flows as well as the pressure variation that consequently affect the dust particle behavior. In the present study, with the use of the commercial code of FLUENT, the distribution of wind velocity and pressure are predicted around coal storage pile yard for four different heights of the wind break wall. From the results, it was found that for the case 1 with the outer windbreak wall height of 3 m and inner windbreak wall height of 6 m, the amount of scattering dust for a year was estimated to be 1451 kg, whereas for the case 4 where a height of outer windbreak wall is 10 m and a height of inner windbreak wall is 16 m, the amount of scattering dust for a year was 358 kg. It shows that the dust scattering can be reduced by 75%, indicating important role of windbreak wall height on particle scattering. The numerical results would be useful in decision of the appropriate height of windbreak wall for decreasing the amount of scattering dust under various environmental conditions.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.14 no.1
• /
• pp.89-104
• /
• 2011

This study was carried out to the development of ecological planting model to make up of coastal windbreak forest on the Suncheon-bay in Sucheon-si, Korea. Make up of coastal windbreak forest in this site was needed for appropriate bioresource, biodiversity and ecological structure, and for conservation of the eco-tour resource and protection of human life and property by the unforeseen disaster from the coast. Based on the plant-social principle, the planting model of windbreak forest was developed to facilitate growth of trees, considering planting locations. The ecological planting model for the coastal windbreak was composed of warm temperate evergreen and windbreak forest which is spreading around the inland area in Korea. The horizontal forest style was composed of forest edge community and inner forest community, and the vertical forest style was composed of upper, middle, low and ground planting class. The target of the present model was quasi-natural forest, and the species of tree were selected based on the adaptability to surroundings depending on a goal to create a forest and forest style. To achieve both functions of wind break forest and visual effect in short period of time, small trees and seedlings were planted with high-density of 40,000/ha in an expectation of easy natural maintenance in the future. The significance of the present study is a suggestion for a guideline to create ecological coastal windbreak forest in the Suncheon-bay in which the harmony of human life and the ecological conservation is of great importance. Also, the ecological coastal windbreak forest model should be developed further through the long term monitoring after construction of forest.

• KIEAE Journal
• /
• v.17 no.4
• /
• pp.59-65
• /
• 2017

Purpose: Thermal performance and air tightness of window are improved for the building energy efficiency. As the deteriorated houses are increased, the improve measures with low cost and easy installation are developed in the energy performance of window. Attached glazing and windbreak can be easily applied to the window with low cost. In this paper, the effect of the attached glazing and windbreak on the thermal performance and air tightness of window is analyzed as the measure to improve performance of window. Method: Thermal transmittance of glazing is evaluated through WINDOW simulation according to thickness of attached glazing and air cavity. Based on the simulation results, thermal transmittance, air tightness and condensation resistance performance of four cases are tested according to Korea standards. One type of PVC sliding double window is chosen as the specimen. For the analysis on low performance of window, the outside of window is excluded in the PVC sliding double window. Result: This study shows that thermal performance of glazing can be increased by the application of attached glazing. Furthermore, lower thermal performance of glazing can obtain the higher effect of attached glazing. The application of attached glazing and windbreak can effect on increasing thermal performance and air tightness of window.

• Journal of Korean Society of Forest Science
• /
• v.97 no.1
• /
• pp.95-101
• /
• 2008

The wind speed reduction capability of forest belt of Caragana Korshinskili Kom in Yanchi, Ningxia province in China is as follows. 1. At the height of 0.5 m, the windbreak effect is 3-Strip (30.22%) > 2-Strip (26.53%) > 1-Strip (16.28%) from 1H (H = Tree Height) to 5H, and the windbreak effect is 2-Strip (16.11%) > 3-Strip (12.79%) > 1-Strip (9.82%) for greater than 7H. Further analysis of 2-Strip and 3-Strip revealed that the wind reduction effect of 2-Strip spread to 44H and 3-Strip spread to 27H. This result implies that 3-Strip is most effective for short distances and 2-Strip is most effective for long distances. 2. At the height of 1.0m, the wind speed was relatively constant and the reduction rate of wind speed had a minimal variation, with the reduction rate of 1-Strip (8.04%), 2-Strip (8.23%), and 3-Strip (7.43%). 3. The sandbreak effect is 2-Strip (55.28%) > 3-Strip (37.13%) > 1-Strip (20.87%). Especially, The rate of sandbreak of 1H (86.06%) of 2-Strip is most effective value in whole data.

• Wind and Structures
• /
• v.28 no.4
• /
• pp.215-224
• /
• 2019

Because of the particularity and complexity of direct air-cooling structures (ACS), wind parameters given in the general load codes are not suitable for the wind-resistant design. In order to investigate the wind loads of ACS, two 1/150 scaled three-span models were designed and fabricated, corresponding to a rigid model and an aero-elastic model, and wind tunnel tests were then carried out. The model used for testing the wind pressure distribution of the ACS was defined as the rigid model in this paper, and the stiffness of which was higher than that of the aero-elastic model. By testing the rigid model, the wind pressure distribution of the ACS model was studied, the shape coefficients of "A" shaped frame and windbreak walls, and the gust factor of the windbreak walls were determined. Through testing the aero-elastic model, the wind-induced dynamic responses of the ACS model was studied, and the wind vibration coefficients of ACS were determined based on the experimental displacement responses. The factors including wind direction angle and rotation of fan were taken into account in this test. The results indicated that the influence of running fans could be ignored in the structural design of ACS, and the wind direction angle had a certain effect on the parameters. Moreover, the shielding effect of windbreak walls induced that wind loads of the "A" shaped frame were all suction. Subsequently, based on the design formula of wind loads in accordance with the Chinese load code, the corresponding parameters were presented as a reference for wind-resistant design and wind load calculation of air-cooling structures.

• Fire Science and Engineering
• /
• v.23 no.3
• /
• pp.1-10
• /
• 2009

This paper presents a study on the evacuation analysis in underground arcade. In this study, the effect of the exit with a windbreak door has been investigated by using evacuation simulation program (building EXODUS). Also, the simulation has included the impact of smoke, heat and toxic gases by fire simulation program (CFAST). The results were obtained for the conditions of without and with door of the two exit with 1,088 evacuation population. As a results, for non-fire evacuation, there was only a little difference of evacuation time for both conditions. However, for fire emergency evacuation, the evacuation time for the condition with door increased more 110 seconds than for the condition without door. When the auto door not opened, the evacuation time was increased more 670 seconds than for the condition without door. Consequently, in case of fire, the automatic door should be operating by the signal of fire detector and keep open when the fire accidents. To lead the evacuees well to the escape route the luminaries for an emergency exit sign have to be reinforced to the wall and floor around the exit.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.63 no.6
• /
• pp.39-47
• /
• 2021

Reduction effect of the spread of odorant and fine dust through windbreak trees can be predicted through numerical analysis. However, there is a disadvantage that a large space and destructive experiments must be carried out each time to calculate the aerodynamic coefficient of the tree. In order to overcome these shortcomings, In this study, we aimed to estimate the aerodynamic coefficient (C₀, C₁, C₂) by using image processing. Thuja occidentalis, which can be used as windbreak were used as the material. The leaf area index was estimated from the leaf area ratio using image processing with leaf weight, and the optical porosity was calculated through image processing of photos taken from the side while removing the leaves step-by-step. Correlation analysis was conducted with the aerodynamic coefficient of Thuja occidentalis calculated from the wind tunnel test and leaf area index and optical porosity calculated from the image analysis. The aerodynamic coefficient showed positive and negative correlations with the leaf area index and optical porosity, respectively. The results showed that the possibility of estimating the aerodynamic coefficient using image processing.

• Korean System Dynamics Review
• /
• v.15 no.3
• /
• pp.81-104
• /
• 2014

This study aimed to suggest the directions for the landscape protection of Sindu-ri coastal dune based on its ecological system. The study investigated ecological systems of the coastal dune followed by damage causes of coastal dune according to the land use change, and landscape value of coastal dune in the study area. In order to construct causal-effect feedback loop, systems thinking was performed. Result of this study showed that the area of coastal dune and the amount of sand are maintained by the interaction with sand beach while they are affected by wind direction, wind speed, and dune plants. It was also found that the changes of land use pattern, increasing commercial area, and planted windbreak forest damaged to the coastal dune. In addition, size of coastal dune and growing number of dune plants increased landscape value of coastal dune and tourist draw. However increasing tourists have constantly affected land use changes and have damaged to coastal dune area. In sum, planning for land use regulation, rest-year system areas, promotion and education for coastal dune, dune plants protection, and windbreak management should be taken into account for landscape protection in coastal dune.