Journal of Mechanical Science and Technology

  • 제17권6호
  • /
  • Pages.896-905
  • /
  • 2003
  • /
  • 1738-494X(pISSN)
  • /
  • 1976-3824(eISSN)
대한기계학회 (The Korean Society of Mechanical Engineers)
권호 표지

Effects of Insulation Layer upon the Thermal Behavior of Linear Motors

  • Eun, In-Ung (Department of Die ＆ Mold Design, Kyonggi Institute of Technology)
  • 발행 : 2003.06.01
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

초록

A linear motor has many advantages next to conventional feed mechanisms: high transitional speed and acceleration, high control performance, and good positioning accuracy at high speed. Through the omission of a power transfer element, the linear motor shows no wear and no backlash, has a long lifetime, and is easy to assemble. A disadvantage of the linear motor is low efficiency and resultant high-temperature rise in itself and neighboring structures during operation. This paper presents the thermal behavior of the linear motor as a feed mechanism in machine tools. To improve the thermal behavior, an insulation layer is used. By placing the insulation layer between the primary part and the machine table, both the temperature difference and the temperature fluctuation in the machine table due to a varying motor load are reduced.

키워드

참고문헌

  1. Eun, I. -U., 1999, 'Optimierung des thermischen Verhaltens von elektrischen Linearmotoren ffuer den Einsatz in Werkzeugmaschinen,' Dissertation, RWTH Aachen
  2. Eun, I. -U., 2001, 'Comparison Between Asynchronous and Synchronous Linear Motors as to Thermal Behavior,' International Journal of the Korean Society of Precision Engineeirng, Vol. 2, No. 3, pp. 61-68
  3. Eun, I. -U., 2002, 'Analysis for the Thermal Behavior of Synchronous Lineark Motor by FEM,' Transactions of the KSME ,A, Vol. 26, No. 8, pp. 1461-1471
  4. Gieras, J. F. and Piech, Z. J., 2000, Linear synchronous motors, CRC Press, Boca Raton
  5. Henneberger, G., 1997, Elektrische Maschinen 3, RWTH Aachen, pp. 40-45
  6. Incropera, F. P. and DeWitt, D. P., 1996, Fundamentals of Heat und Mass Transfer, 4th Edition, John Wiley & Sons, New York, pp. 212-214
  7. Ispaylar, H., 1996, 'Betriebsverhalten von Profilschienen-Waelzfuehrung,' Dissertation, RWTH Aachen
  8. Sogabe, M., 1994, High Speed Machining and Linear Motor, 6th IMEC
  9. Weck, M., 2001, Wekzeugmaschinen-Mechatronische Systeme,Vorschubantriebe, Prozessdiagnose, Springer-Verlag, Berlin Heidelberg New York
  10. Weck, M., 2001, Werkzeugmaschinen-Messtechnische Untersuchung und Beurteilung, Springer Verlag, Berlin Heidelberg New York, pp. 80-82