A Study on the Molding Technology for the Preform of Blow Molding Through Compression Molding

압축성형을 통한 블로우 성형품용 프리폼 성형기술 연구

  • 최성현 (서울산업대학교 대학원) ;
  • 민형기 (서울산업대학교 대학원) ;
  • 류민영 (서울산업대학교 금형설계학과)
  • Published : 2007.02.01


Novel compression molding system for preform has been developed in this study. The preforms for injection blow molding and injection stretch blow molding are being manufactured by injection molding. However it contains gate mark that affects the bottom crack in the PET bottle. The compression molded preform does not contain gate mark, thus the appearance quality of bottle has been increased and the residual stress near gate(bottom of the bottle) has been reduced. The thickness distributions, haze, and transmittance are well accepted for the preform. Also, flow characteristics of the resin between a core and cavity could be analyzed through computer simulation.



  1. 류민영, 전재후, 배유리, 2005, 압축 블로우 성형에서 성형조건에 따른 성형특성, 한국소성가공학회지, 제 14 권 3호, pp. 233-238
  2. 류민영, 2002, 플라스틱 성형법의 개요와 연구 동향의 고찰, 한국소성가공학회지, 제 11 권 8 호, pp. 651-667
  3. 주성태, 김용환, 류민영, 2001, 유한요소법을 이용한 PET 병의 성형공정 해석, 한국소성가공학회지, 제 10 권 7 호, pp. 525-533
  4. Min-Young Lyu, H. C. Kim, J. S. Lee, H. C. Shin, Youlee Pew, 2001, Causes of Cracks in Pataloid Bottom of Carbonated PET Bottle, International Polymer Processing, 16, pp. 72-78
  5. Min-Young Lyu, H. C. Kim, H. C. Shin, J. S. Lee, S. T. Joo, Y. W. Kim, 2001, A Study on the Bottom Design of Petaloid Carbonated PET Bottle to Prevent Bottom Crack, SPE ANTEC Technical Papers, 47, 2808
  6. Min-Young Lyu, Yong Hwan Kim, 2002, Investigation of Design Parameters and Novel Design of Petaloid PET Bottles, International Polymer Processing, Vol. 17, No.3, pp. 279-283
  7. Min-Young Lyu, Youlee Pae, 2003, Bottom Design of Carbonated Soft Drink Polyethylene Terephthalate Bottle to Prevent Solvent Cracking, J of Applied Polymer Science, Vol. 88, pp. 1145-1152
  8. Min-Young Lyu, Youlee Pae, Changwoon Nah, 2003, Investigation of Bottom Cracks in Carbonated Poly (Ethylene Terephthalate) Bottle, Elastomer, Vol. 38, No.4, pp. 354-362