Abstract
Digital topographical maps used for GIS DB are mainly produced by the traditional way of analogue aerial photogrammetry. Therefore, analogue photos are only available for digital mapping after preprocessing such as film developing, printing and scanning. However, digital aerial camera is able to get digital image directly without preprocessing and thus the performance and efficiency of photogrammetry are extremely increased. This study aims to investigate geometric stability of digital aerial frame camera DMC (Digital Modular Camera). In order to verify the geometric stability of digital aerial camera DMC, some different block conditions with and without cross strips, GPS/INS data and variation of GCPs are introduced in the block adjustment. The accuracy results of every block condition were compared each other by computation of residuals of exterior orientation (EO) parameters. Results of study shows that the geometric stability of the block adjustment with cross strips is increased about 30% against without cross strips. The accuracy of EO parameters of block adjustment with cross strips is also increased about 2cm for X-coordinate, 3cm for Y-coordinate, 3cm for Z-coordinate, and 6" for omega, 4" for phi and 3" for kappa.
GIS의 자료기반이 되는 수치지도는 주로 재래식 항공사진측량에 의해서 제작되고 있다. 따라서 촬영된 아날로그 항공사진은 필름의 현상, 인화, 스캐닝 작업 과정을 거쳐 수치지도 제작에 이용되고 있다. 하지만 디지털 항측카메라의 개발로 촬영된 사진의 전처리과정 없이 직접 디지털 영상의 획득이 가능하여 항공사진의 효율성이 극대화 되고 있는 실정이다. 본 연구 에서는 면형방식 카메라인 DMC(Digital Modular Camera) 영상의 블록구성에 따른 기하적 안정성을 검증하기 위하여 횡스트립의 유무, GPS/INS 외부표정요소의 유무 및 지상기준점 수를 달리한 조건으로 블록조정을 수행하였다. 각 조건별 블록조정의 결과로 부터 외부표정요소에 대한 잔차의 변화를 계산하여 정확도를 상호 비교하였다. 연구 결과 횡스트립 추가 시 블록은 기하학적으로 약 30% 안정함을 알 수 있었고, 외부표정요소에서는 횡스트립 추가 시 표준편차의 평균에서 X축으로 2cm, Y축으로 3cm, Z축으로 3cm 더 우수하였으며, omega는 6", phi는 4", kappa는 3" 더 우수하게 나타났다.