RF 마그네트론 스퍼터링법으로 제작된 ITO 박막의 공정압력 변화에 따른 특성

Properties of ITO thin films deposited by RF magnetron sputtering with process pressure

  • 정성진 (청주대학교 전자공학과) ;
  • 김덕규 (충북대학교 전자공학부) ;
  • 김홍배 (청주대학교 전자정보공학부)
  • Jeong, Seong-Jin (Electronic Engineering of Cheongju University) ;
  • Kim, Deok-Kyu (School of Electronic Engineering, Chungbuk national University) ;
  • Kim, Hong-Bae (school of Electronic and Information Engineering, Cheongju University)
  • 투고 : 2010.11.30
  • 심사 : 2010.12.17
  • 발행 : 2010.12.31

초록

The transparent electrode properties of ITO films deposited by RF magnetron sputtering with process pressure were investigated. The ITO thin films was deposited on a glass substrate using a target with 3in diameter sintered at a ratio of $In_2O_3$ : $SnO_2$ (9 : 1). 200-nm-thick ITO thin films were manufactured by various process pressures ($2.0{\times}10^{-2}$, $7.0{\times}10^{-3}$ and $2.0{\times}10^{-3}$ Torr). The optical transmittance and resistivity of the deposited ITO thin films showed a relatively satisfactory result under $10^{-2}$ Torr. For high process pressure, the optical transmittance was below 80%, while for low process pressure, the optical transmittance was above 85%. As a result of of mobility, resistivity and carrier concentration by Hall measurement, we obtained satisfactory properties to apply into a transparent conducting thin film.

키워드

참고문헌

  1. Nisha, M.; Jayaraj, M. K. "Influence of RF power and fluorine doping on the properties of sputtered ITO thin films", Applied Surface Science, Vol. 255, pp. 1790-1795, 2008 https://doi.org/10.1016/j.apsusc.2008.06.019
  2. Suresh, A.; Gollakota, P.; Wellenius, P.; Dhawan, A.; Muth, J. F."Transparent, high mobility InGaZnO thin films deposited by PLD", Thin Soild Films, Vol. 516, pp. 1326-1329, 2008 https://doi.org/10.1016/j.tsf.2007.03.153
  3. Lai, L. W.; Lee, C. T. "Investigation of optical and electrical properties of ZnO thin films", Materials Chemistry and Physics, Vol. 110, pp. 393-396, 2008 https://doi.org/10.1016/j.matchemphys.2008.02.029
  4. Li, Q. H.; Zhu, D. L.; Liu, W. J.; Liu, Y.; Ma, X. C. "Optical properties of Al-doped ZnO thin films by ellipsometry", Applied Surface Science Vol. 254, pp. 2922-2926, 2008 https://doi.org/10.1016/j.apsusc.2007.09.104
  5. Jeong, J. A.; Choi, K H.; Bae, J. H.; Moon, J. M.; Jeong, S. W.; Kim, I. S.; Kim, H. K.; Yi, M. S. "Electrical, optical, and structural properties of ITO co-sputtered IZO films by dual target magnetron sputtering", J Electroceram. Vol. 23, pp. 361-366, 2009 https://doi.org/10.1007/s10832-008-9468-4
  6. Zhou, J. M. "Indium tin oxide(ITO)deposition, patterning, and Schottky Contact Fabrication", Department of microelectronic engineering college of engineering rochester institute of technology rochester, new york, 2005
  7. Makia, K.; Komiya, N.; Suzuki, A. "Fabrication of thin films of ITO by aerosol CVD", Thin Solid Films, Vol. 445, pp. 224-228, 2003 https://doi.org/10.1016/j.tsf.2003.08.021
  8. Sasabayashi, T.; Ito , N.; Nishimura , E.; Kon, M.; Song, P.K.; Utsumi, K.; Kaijo, A.; Shigesato, Y. "Comparative study on structure and internal stress in tin-doped indium oxide and indium-zinc oxide films deposited by r.f. magnetron sputtering", Thin Solid Films, Vol. 445, pp. 219-223, 2003 https://doi.org/10.1016/j.tsf.2003.08.047
  9. Suzuki, M.; Maeda, Y.; Muraoka, M.; Higuchi, S. ; Sawada, Y. "ITO films sputter-deposited using an ITO target sintered with vanadium oxide additive", Materials Science and Engineering, Vol. 54, pp. 43-45, 1998 https://doi.org/10.1016/S0921-5107(98)00124-X
  10. Fallah, H. R.; Ghasemi, M.; Hassanzadeh, A.; Steki, H. "The effect of annealing on structural, electrical and optical properties of nanostructured ITO films prepared by e-beam evaporation", Materials Research Bulletin, Vol. 42, pp. 487-496, 2007 https://doi.org/10.1016/j.materresbull.2006.06.024
  11. Ma, j.; Zhang, D. H.; Zhao, J. Q.; Tan, Chuenyu.; Yang, T. L.; Ma, H. L. "Preparation and characterization of ITO films deposited on polyimide by reactive evaporation at low temperature" Applied Surface Science, Vol. 151, pp. 239-243, 1999 https://doi.org/10.1016/S0169-4332(99)00279-2
  12. Meng, L. J.; Dos Santos, M.P. "Properties of indium tin oxide films prepared by rf reactive magnetron sputtering at different substrate temperature", Thin Solid Films Vol. 322, pp. 56-62, 1998 https://doi.org/10.1016/S0040-6090(97)00939-5
  13. Salehi, A. "The effects of deposition rate and substrate temperature of ITO thin films on electrical and optical properties", Thin Solid Films Vol. 324, pp. 214-218, 1998 https://doi.org/10.1016/S0040-6090(98)00371-X