Journal of the Korean Society of Manufacturing Process Engineers (한국기계가공학회지)

The Korean Society of Manufacturing Process Engineers (한국기계가공학회)
권호 표지

The Establishment of Bonding Conditions of Cu Sheet using an Ultrasonic Metal Welder

초음파 금속 용착기를 이용한 Cu 박판의 접합성 평가

  • 박우열 (인천대학교 대학원 기계공학과) ;
  • 장호수 (인천대학교 대학원 기계공학과) ;
  • 박동삼 (인천대학교 기계시스템공학부)
  • Published : 2012.04.30
⟨ Previous Next ⟩

Abstract

Ultrasonic metal welder is consisted of power supply, transducer, booster, and horn. Precise designing is required since each part's shape, length and mass can affect driving frequency and vibration mode. This paper gives a description of an experimental study of the ultrasonic welding of metals. A horn suitable for 40,000Hz was attached to the ultrasonic metal welder in order to weld Cu sheet. The Cu sheet welding was done with different amplitude, pressure and welding time, and its maximum tension was measured. Maximum tension of 177.99N was obtained when the pressure was 2.5bar, amplitude was 80%, and welding time was 0.34sec. Therefore, excessive welding condition negatively influences maximum tension measurement result.

Keywords

References

  1. Fujikura, R., "High Pin-Count Ultrasonic Flip-Chip Bonding and Plasma Cleaning Technology", Proceedings of 9th annual KGD Workshop., Napa, California, 2002.
  2. Maruo, H., Seki, Y., Unami, Y., and Ominato, T., "Ultrasonic Flip Chip Bonding on FPC", Fujikura Technical Review, pp. 36-39, 2004.
  3. Lee, C. K., Hwang, B. J., and Heu, I. H., "Bonding of Electric Wire by Ultrasonic Welding", Journal of the Korean Society of machine Tool Engineers., Vol. 9, No. 4, pp. 41-47, 2008.
  4. Lee, S., I., and Hong, S., H., "Nonliner Analysis of ultrasonic horn model for flip-chip bonding", Proceedings of the KSMTE Autumn Conference pp. 523-528, 2007.
  5. Jung, J., P., "Ultrasonic Bonding of Electronic Parts", Kwjs 2008-Autumn, pp. 7-9, 2008.
  6. John Wnek, "Ultrasonic metal welding for wire splicing and termination", Branson Ultrasonic Corp.
  7. "Ultrasonic metal welding - Horizontal oscillation direction", STAPLA Ultrasonic Corp.
  8. Lee, B. G., Kim K. L., and Kim, K. E., "Design of Ultrasonic Vibration Tool Horn for Micromachining Using FEM", Vol. 17, No. 6, pp. 63-70, 2008.
  9. Seah, K. H. W., Wong, Y. S., and Lee, L. C., "Design of tool holders for ultrasonic machining using FEM", Journal of Materials Processing Technology, Vol. 37, pp. 810-816, 1993.
  10. Liu, Z., Kim, H. S., Pack, J. R., Kim, J. T., "Surface profile measurement with FFT method and stabilized interferometer", Proceedings of the KSMTE Autumn Conference, pp. 269-273, 2004.