A Study on Proper Location of Welding Defect in Three Point Bend Testing with MDPE Pipe

  • Received : 2015.02.05
  • Accepted : 2015.03.18
  • Published : 2015.03.31


Welding defects affect the performance of welded pipe joints. In this study, a three point bend test of welded steel and medium density polyethylene (MDPE) pipe joints with defects of various defect locations and defect materials was studied using the finite element method. The defect was assumed to be located at 12 o'clock, 3 o'clock or 6 o'clock direction. The results showed that pipes failed more easily on the compression side due to stress or local buckling. The air defect was more dangerous than the steel defect if the defect was located in the compression side; otherwise, the defect material effect on the integrity of pipes was ignorable. It is argued that the integrity of pipes with defects in the compression side is weaker than that in other regions, and the defect should be located in the compression side or the 12 o'clock position in the three point bend test to maximize the effect of defect existence on the pipe structural integrity.


Supported by : NRF, KETEP


  1. Leskovics, K., Kollar, M. and Barczy, P.: "A study of structure and mechanical properties of welded joints in polyethylene pipes", Material Science and Engineering: A, vol. 419, 138-143, (2006)
  2. Lee, B. Y., Kim, J. S., Lee, S. Y. and Kim, Y. K.: "Butt-welding technology for double walled polyethylene pipe", Material & Design, vol. 35, 626-632, (2012)
  3. Ezrin, M.: "Plastic failure guide-cause and prevention", Munich, Hanser, (1996)
  4. Barker, M. B., Bowman, J. and Bevis, M.: "Fatigue properties of high-density polyethylene pipe systems", Journal of Material Science, vol. 15, 265-268, (1980)
  5. DVS 2202-1: "Imperfections in thermoplastic welded joints - Features, description, evaluation", (2008)
  6. Kil, S. H., Jo, Y. D. and Yoon, K. B.: "The case study of phase array ultrasonic for polyethylene pipeline in the electrofusion joints", the 12th International Conference Pressure Vessel Technology, Jeju, South Korea, (2009)
  7. Shi, J. F., Zheng, J. Y., Guo, W. C. and Qin, Y. Q.: "Defects classification and failure modes of electrofusion joint for connecting polyethylene pipes", Journal of Applied Polymer Science, vol. 124, 4070-4080, (2012)
  8. Lai, H. S., Kil, S. H. and Yoon, K. B.: "Effect of defect size on failure of butt fusion welded MDPE pipe under tension", Journal of Mechanical Science and Technology, Accepted for Publication, (2015)
  9. Lai, H. S., Kil, S. H. and Yoon, K. B.: "The effects of defects on the burst failure of butt fusion welded polyethylene pipe", Engineering Failure Analysis, Submitted, (2015)
  10. Kil, S. H.: "Effect of defects in butt fusion welding on integrity of polyethylene gas pipe", PhD Thesis, Chung-Ang University, Seoul, Korea, (2014)
  11. Ostby, E. and Hellesvik, A. O.: "Large-scale experimental investigation of the effect of biaxial loading on the deformation capacity of pipes with defects", International Journal Pressure and Vessel Piping, vol. 85, 814-824, (2008)
  12. Mujika, F.: "On the effect of shear and local deformation in three point bending tests", Polymer Testing, vol. 26, 869-877, (2007)