Journal of Electrical Engineering and Technology

  • 제12권3호
  • /
  • Pages.1187-1194
  • /
  • 2017
  • /
  • 1975-0102(pISSN)
  • /
  • 2093-7423(eISSN)
대한전기학회 (The Korean Institute of Electrical Engineers)
권호 표지
DOI QR코드

DOI QR Code

A Non-isolated High Step-up DC/DC Converter with Low EMI and Voltage Stress for Renewable Energy Applications

  • Baharlou, Solmaz (Dept. of Electrical Engineering, Isfahan (Khorasgan) Branch, Islamic Azad University) ;
  • Yazdani, Mohammad Rouhollah (Dept. of Electrical Engineering, Isfahan (Khorasgan) Branch, Islamic Azad University)
  • 투고 : 2016.08.16
  • 심사 : 2017.02.17
  • 발행 : 2017.05.01
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

초록

In this paper, a high step-up DC-DC PWM converter with continuous input current and low voltage stress is presented for renewable energy application. The proposed converter is composed of a boost converter integrated with an auxiliary step-up circuit. The auxiliary circuit uses an additional coupled inductor and a balancing capacitor with voltage doubler and switching capacitor technique to achieve high step-up voltage gain with an appropriate switch duty cycle. The switched capacitors are charged in parallel and discharged in series by the coupled inductor, stacking on the output capacitor. In the proposed converter, the voltage stress on the main switch is clamped, so a low voltage switch with low ON resistance can be used to reduce the conduction loss which results in the efficiency improvement. A detailed discussion on the operating principle and steady-state analyses are presented in the paper. To justify the theoretical analysis, experimental results of a 200W 40/400V prototype is presented. In addition, the conducted electromagnetic emissions are measured which shows a good EMC performance.

키워드

참고문헌

  1. S. Subramanian and T. Subbaiyan, "A Simple Power Management Scheme with Enhanced Stability for a Solar PV/Wind/Fuel Cell Fed Standalone Hybrid Power Supply using Embedded and Neural Network Controller," J. Electr. Eng. Technol., vol. 9, no. 5, pp. 1454-1470, 2014. https://doi.org/10.5370/JEET.2014.9.5.1454
  2. Mi-Young Kim and Yong-Un Song, "The Analysis of Active Power Control Requirements in the Selected Grid Codes for Wind Farm," J. Electr. Eng. Technol., vol. 10, no. 4, pp.1408-1414, 2015. https://doi.org/10.5370/JEET.2015.10.4.1408
  3. M. A. Khlifi, "Study and Control of Photovoltaic Water Pumping System," J. Electr. Eng. Technol., vol. 11, no. 1, pp. 117-124, 2016. https://doi.org/10.5370/JEET.2016.11.1.117
  4. B. Liu, S. Duan, and T. Cai, "Photovoltaic DCbuilding-module-based BIPV system-concept and design considerations," IEEE Trans. Power Electron., vol. 26, no. 5, pp. 1418-1429, 2011. https://doi.org/10.1109/TPEL.2010.2085087
  5. F. L. Tofoli, D. d. C. Pereira, W. Josias de Paula and D. d. S. Oliveira Junior, "Survey on non-isolated high-voltage step-up dc-dc topologies based on the boost converter," IET Power Electron., vol. 8, no. 10, pp. 2044-2057, 2015. https://doi.org/10.1049/iet-pel.2014.0605
  6. K. I. Hwu and T. J. Peng, "High Step-Up Converter with Hybrid Structure Based on One Switch," J. Electr. Eng. Technol., vol. 10, no. 4, pp.1566-1577, 2015. https://doi.org/10.5370/JEET.2015.10.4.1566
  7. O. Abutbul, A. Gherlitz, Y. Berkovich, and A. Ioinovici, "Step-up switching-mode converter with high voltage gain using a switched-capacitor circuit," IEEE Trans. Syst. I, Fundam. Theory Appl., vol. 50, no. 8, pp. 1098-1102, 2003. https://doi.org/10.1109/TCSI.2003.815206
  8. D. Novaes, Y.R. Rufer, A. Barbi, "A new quadratic, three-level, dc/dc converter suitable for fuel cell applications," in Proc. Power Conversion Conf., 2007, pp. 601-607.
  9. E. H. Ismail, M. A. Al-Saffar, A. J. Sabzali and A. A. Fardoun, "A Family of single-switch PWM converters with high step-up conversion ratio," in IEEE Trans. Circuits and Systems I: Regular Papers, vol. 55, no. 4, pp. 1159-1171, 2008. https://doi.org/10.1109/TCSI.2008.916427
  10. J. C. Rosas-Caro, J. M. Ramirez, F. Z. Peng and A. Valderrabano, "A DC-DC multilevel boost converter," IET Power Electron., vol. 3, no. 1, pp. 129-137, 2010. https://doi.org/10.1049/iet-pel.2008.0253
  11. Q. Zhao and F. C. Lee, "High-efficiency, high step-up dc-dc converters," IEEE Trans. Power Electron., vol. 18, no. 1, pp. 65-73, 2003. https://doi.org/10.1109/TPEL.2002.807188
  12. T. J. Liang and K. C. Tseng, "Analysis of integrated boost-flyback step up converter," in Proc. Inst. Elect. Eng. - Elect. Power Appl., vol. 152, no. 2, pp. 217-225, 2005. https://doi.org/10.1049/ip-epa:20045003
  13. Y. P. Hsieh, J. F. Chen, T. J. Liang, and Y. L. -Sheng, "Analysis and implementation of a novel singleswitch high step-up dc-dc converter," IET Power Electron., vol. 5, no. 1, pp. 11-21, 2012. https://doi.org/10.1049/iet-pel.2010.0279
  14. Y.-P. Hsieh, J.-F. Chen, T.-J. Liang, and L.-S. Yang, "Novel high step-up DC-DC converter with coupledinductor and switched-capacitor techniques," IEEE Trans. Ind. Electron., vol. 59, no. 2, pp. 998-1007, 2012. https://doi.org/10.1109/TIE.2011.2151828
  15. K. C. Tseng, J. T. Lin, and C. C. Huang, "High stepup converter with three-winding coupled inductor for fuel cell energy source applications," IEEE Trans. Power Electron., vol. 30, no. 2, pp. 574-581, 2015. https://doi.org/10.1109/TPEL.2014.2309793
  16. H. Liu, H. Hu, H. Wu, Y. Xing and I. Batarseh, "Overview of High-Step-Up Coupled-Inductor Boost Converters," IEEE Jour. of Emerg. and Sel. Top. in Power Electron., vol. 4, no. 2, pp. 689-704, 2016. https://doi.org/10.1109/JESTPE.2016.2532930
  17. X. Hu, and C. Gong, "A high voltage gain DC-DC converter integrating coupled-Inductor and diodecapacitor Techniques," IEEE Trans. Power Electron., vol. 29, no. 2, pp. 789-800, 2014. https://doi.org/10.1109/TPEL.2013.2257870
  18. Y. Deng, Q. Rong, W. Li, Y. Zhao, J. Shi, and X. He, "Single-switch high step-up converters with built-in transformer voltage multiplier cell," IEEE Trans. Power Electron., vol. 27, no. 8, pp. 3557-3567, 2012. https://doi.org/10.1109/TPEL.2012.2183620
  19. K. B. Park, G. W. Moon, and M. J. Youn, "Non isolated high step-up boost converter integrated with SEPIC converter," IEEE Trans. Power Electron., vol. 25, no. 9, pp. 2266-2275, 2010. https://doi.org/10.1109/TPEL.2010.2046650
  20. C. Krishnakumar, et al., "A New Random PWM Technique for Conducted-EMI Mitigation on Cuk Converter," J. Electr. Eng. Technol., vol. 10, no. 3, pp. 916-924, 2015. https://doi.org/10.5370/JEET.2015.10.3.916