Primary radiation force on ultrasound contrast agents (UCA) in a propagating and standing acoustic field was explored. A specific ultrasound contrast agent $Albunex^{(R)}$ and $Optison^{(R)}$ were chosen for simulation. The model was developed based on a shelled bubble model proposed by Church. The numerical simulation suggests that bubble translational motion is more significant in therapeutic ultrasound due to higher intensity and long pulse duration. Even a single cycle of a propagating wave of 4 MPa at 1 MHz can cause a bubble translational motion of greater than $1{\mu}m$ which is approximately one tenth of capillary. Hence, UCA characteristics can be significantly changed in therapeutic ultrasound without rapid bubble collapses.

In this paper, FSTL (Field Sound Transmission Loss) measured in a mock-up simulating ship cabins is studied. A mock-up is built by using 6 mm steel plate, and two identical cabins are made where 25 mm or 50 mm sandwich panel is used to construct wall and ceiling inside the steel structure. Various wall panels and ceilings are tested, where effects of wall and ceiling panel thickness, and presence of a unit toilet on FSTL are investigated. It is found that the effect of unit toilet on FSTL is at most 1 dB. From the comparison of FSTL for panels of the same thickness of 50 mm, it is observed that panel having inside air cavity of 10 mm shows higher STL than that of the panel without air cavity. Comparison of FSTL for panels of 50 mm and 25 mm thickness shows that dependency on surface density predicted by mass law is not observed. The sandwich panels act as a mass-spring system, which shows a resonant mode that cannot be explained by the mass law. It is also found that STL from laboratory test is higher than FSTL by 5- 10 dB, which can be explained by flanking structure-borne noise transmission path such as ceiling, floor and corridor-facing wall.

In this paper, the new robust active noise controller was proposed to be applied for attenuating the noises when the nonlinear distortion in the secondary path exists. Through computer simulations as well as the analytical analysis, it could be shown that it is possible for both conventional LMS controller and proposed controller, to be applied for actively controlling the noises and linearizing the nonlinear distortion in the secondary path. Also, the simulations results demonstrated that the proposed controller may have faster convergence speed and better capability of controlling the noises and compensating the nonlinear distortion than the conventional LMS controller.

At the crossings of turnout systems, noise is generated by the impact of train on the connection points. However, rapid movement changes between rail and wheels on connection point are inevitable on existing turnout section which may cause safety concern as well as noise problem caused by repeated impact load by passing train. And given the turnout is a complicated system which combines various functions such as rolling stock, trackbed, signaling, communication and electrical system, it's very difficult to expect to improve the overall performance of the turnout in such a way of optimizing only particular part of such integrated system. Since the turnout is the only movable section among the integrated parts and has complicated structure that inevitably brings about quick and sudden movement, safety has been still put on the top of the list. This study was aimed at comparing and analyzing the noise data obtained around the turnout of existing railway, by categorizing them into tilting train, high speed train and traditional train, and by distance, speed and type of turnout. And based on the data measured, the forecast of noise level when tilting train accelerates around a turnout was conducted in the study.

MPEG4 High Efficiency Advanced Audio Coding (HE-AAC) and MPEG Surround are one of the most efficient combinations for low bit rate multi-channel audio coding. Based on the fact that these two codecs have identical quadrature mirror filter (QMF) analysis and synthesis structures, we propose a dual-domain connection scheme for the codecs. Specifically two time-domain connection methods are analyzed and compared to the QMF subband-domain connection method. Experimental results show that both the time-domain connection methods cause no subjective sound quality degradation compared to the QMF subband-domain connection method, which verifies that one can select either of them depending on application scenarios.