DOI QR코드

DOI QR Code

Dynamic Voltage Restorer (DVR) for 6.6[kV]/60[Hz] Power Distribution System Using Two Quasi Z-Source AC-AC Converters

두 개의 Quasi Z-소스 AC-AC 컨버터에 의한 6.6[kV]/60[Hz] 배전계통의 동적 전압 보상기(DVR)

  • Received : 2011.10.01
  • Accepted : 2012.01.27
  • Published : 2012.02.01

Abstract

This paper proposes a quasi Z-source DVR(Dynamic Voltage Restorer) system with a series connection of the output terminals, to compensate the voltage variations in the 6.6[kV]/60[Hz] power distribution system. The conventional DVR using one quasi Z-source AC-AC converter has the advantage which it can compensate the voltage variations without the need for the additional energy storage device such as a battery, but it is impossible to compensate for the 50[%] under voltage sags. To solve this problem, a DVR system using two quasi Z-source AC-AC converters with the series connection of the output terminals is proposed. By controlling the duty ratio D in the buck-boost mode, the proposed system can control the compensation voltage. For case verification of the proposed system, PSIM simulation is achieved. As a result, in case that the voltage sags-swells occur 10[%], 20[%], 60[%] in power distribution system, and, in case that the 50[%] under voltage sags-swells continuously occur, all case could compensate by the proposed system. Especially, the compensated voltage THD was examined under the condition of the 10[%]~50[%] voltage sags and the 20[${\Omega}$]~100[${\Omega}$] load changes. The compensated voltage THD was worse for the higher load resistances and more severe voltage sags. Finally, In case of the voltage swells compensation, the compensation factor has approached nearly 1 regardless of the load resistance changes, while the compensation factor of voltage sags was related to the load variations.

Keywords

References

  1. Eric John, "Experience with a Static Series Compensation Device(DVR) at a Semiconductor Facility", ABB Power T&D Company Inc., April 1999.
  2. D. Mahinda Vilathgamuwa et al, "Voltage Sag Compensation With Energy Optimized Dynamic Voltage Restorer", IEEE Trans., Power Delivery, Vol.18, No.3, pp.928-936, July 2003. https://doi.org/10.1109/TPWRD.2003.813880
  3. Mark F. McGranaghan et al, "Voltage Sags in Industrial Systems", IEEE Trans. on Ind. Applicat., Vol.29, No.2, PP.397-403, 1993 https://doi.org/10.1109/28.216550
  4. 전영환, 김지원, 전진홍, "직렬 전압 주입에 의한 순간 전압 강하 보상기기에 관한 연구", 한국에너지공학회지, Vol. 10, No. 4, pp.310-317, 2001.
  5. Y.W. Li, P.C. Loh, F. Blaabjerg, and D. M. Vilathgamuwa, "Investigation and Improvement of Transient Response of DVR at Medium Voltage Level", IEEE Trans. Ind. Applicat., Vol. 43, No. 5, pp. 1309-1319, 2007. https://doi.org/10.1109/TIA.2007.904430
  6. M. Vilathgamuwa, A. A. D. R. Perera, S. S. Choi, and K. J. Tseng, "Control of Energy Optimized Dynamic Voltage Restorer", in Proc. IEEE IECON'99, 1999, pp. 873-878.
  7. T. Jimichi, H. Fujita, and H. Akagi, "Design and Experimentation on a Dynamic Voltage Restorer Capable of Significantly Reducing an Energy- Storage Element", in Proc. IEEE IAS'05, 2005, pp. 896-903.
  8. D. M. Vilathgamuwa, C. J. Gajanayake, P. C. Loh, and Y. W. Li, "Voltage Sag Compensation with Z-Source Inverter Based Dynamic Voltage Restorer", in Proc. IEEE IAS'06, 2006, pp. 2242-2248.
  9. M.K. Nguyen, Y. G. Jung, and Y.C. Lim, "Single-Phase Z-Source Voltage Sag/Swell Compensator", in Proc. IEEE ISIE'09, 2009, 24-28.
  10. 이기택, 정영국, 임영철, "단상 Quasi Z-소스 동적 전압 보상기", 전력전자학회 논문지, Vol. 15, No. 4, pp.327-334, 2010.