The current drive in a MOSFET is limited by the intrinsic channel resistance. All other parasitic elements in a device structure perform significant functions leading to degradation in the device performance. These other resistances must be less than 10$\%$-20$\%$ of the channel resistance. To meet the necessary requirements, the methodology of separation and quantification of those resistances should be investigated. In this paper, we developed an extraction method for the resistances using calibrated TCAD simulation. The resistance of the extension region is also partially determined by the formation of a surface accumulation region that gathers below the gate in the tail region of the extension profile. This resistance is strongly affected by the abruptness of the extension profile because the steeper the profile is, the shorter this accumulation region will be.

Photoreflectance (PR) has been measured to investigate the characterization of the Si$_{3}$N$_{4}$Al$_{0.21}$ Ga$_{0.79}$As/GaAs and Al$_{0.21}$Ga$_{0.79}$As/GaAs heterostructures. In the PR spectrum, the caplayer thickness was 170 nm and Si$_{3}$N$_{4}$ was utilized as the capping material. The C peak is confirmed as the carbon defect with residual impurity originating from the growth process. After annealing, in the presence of the Si$_{2}$N$_{4}$ cap layer, band gap energy was low shifted. This result indicates that the Si$_{3}$N$_{4}$ cap layer controlled evaporation of the As atom.

A trench MOS barrier Schottky (TMBS) rectifier is proposed which utilizes the upper half of the trench sidewall as an active area. The proposed structure improves the forward voltage drop by 20$\%$ in comparison with the conventional one without degradation in breakdown voltage. An analytical model for the field distribution is given and compared with two-dimensional numerical simulations.

This paper describes analysis and pattern recognition techniques for Partial Discharge(PD) signals in Gas Insulated Switchgears (GIS). Detection of PD signals is one of the most important factors in the predictive maintenance of GIS. One of the methods of detection is electro magnetic wave detection within the Ultra High Frequency (UHF) band (300MHz $\~$ 3GHz). In this paper, PD activity simulation is generated using three types of artificial defects, which were detected by a UHF PD sensor installed in the GIS. The detected PD signals were performed on three-dimensional phi-q-n analysis. Finally, parameters were calculated and an Artificial Neural Network (ANN) was applied for PD pattern recognition. As a result, it was possible to discriminate and classify the defects.

Cable failure investigations must evaluate all facets of cable technology to reach a complete understanding of why and how an underground power cable failed. This paper presents the salient points of a recent investigation into an in-service failure after only several weeks of operation.

In oil-filled equipment such as transformers, partial discharge or local overheating will precede a final shutdown. Accompanied with such problems is a decomposition of insulating material into gases, which are dissolved into the transformer oil. The gases dissolved in oil can be separated with some membranes based on the differences in permeability of membranes to different gases. This paper discuss the permeability characteristics of several membranes for separation hydrogen gas in oil. With result of this paper, it may become possible to detect fault-related gases from transformer oil and predict incipient failures in the

In this paper, a miniaturized ring hybrid circuit is characterized based on a thin film microstrip (TFMS) on low-resistivity silicon. In order to obtain low-loss characteristics, a polyimide layer with 50 $\mu$m thickness is spin-coated onto the silicon to be used for the substrate. First, propagation characteristics of TFMS lines consisting of the ring hybrid circuit are presented. Then, a ring hybrid circuit based on TFMS is featured by employing the triple concentric circle approach for miniaturization. Triple concentric circle lines with $\lambda$$_{g}$/4 or 3$\lambda$$_{g}$/4 line lengths are implemented on the surface of the polyimide by circularly meandering to reduce the circuit size of the designed ring hybrid. Good agreement between measured and simulated results is obtained.

This paper presents some interesting results regarding the harmonic performance on the photonic band-gap (PBG) structures formed by periodic conducting vias. Study on PBG structures has been one of the major topics in electromagnetics, microelectronics, and communications areas. In most of the studies, the band-gap filtering behavior was fulfilled by a periodic pattern of perforations on the ground planes of microstrip lines. Nevertheless, the PBG characteristics can also be realized using a periodic via-pattern along the transmission-line circuits. Hence, some of the via-typed PBG structures are studied and their frequency characteristics in terms of the scattering parameters are presented. It is found that by varying the length of vias with respect to the period pattern, different harmonic performances are observed.