EM (ElectroMagnetic) pump is used for the purpose of transporting liquid sodium coolant with electrical conductivity in the LMR(Liquid Metal Reactor). (In the present study, pilot EM pump has been designed by using of equivalent circuit method which is commonly employed to analyze linear induction machines for the test of removal of residual heat. The length and diameter of the pump have fixed values of 840 mm and 101.6 mm each by taking account of geometrical size of circulation loop for the installation of EM pump. Flowrate versus developing pressure is related from Laithwaite's standard design formula and the characteristic analyses of developing force and efficiency are carried out according to change of input frequency. From the characteristic curve, input frequency of 13 Hz is determined as the design frequency. On the other hand, The annular air gap size of 6.05 mm is selected not to bring about too much hydraulic loss. Resultantly design analysis makes pump have the electrical input of 604 VA and the hydrodynamical capacity of 1.3 bars and 40 l/min.

We have performed spin-spray ferrite plating of $Fe_{3-x}Zn_xO_4$($X=0.47{\sim}0.97$) films in the temperature region T=85[$^{\circ}C$]. A reaction solution and an oxidizing solution were supplied to a reaction chamber by supply pumps. The Zn composition X in the $Fe_{3-x}Zn_xO_4$ Film increases as the content of $ZnCl_2$ increase, from X=0.47 at O.05[g/l] to X=0.97 at 0.15[g/l]. All the films are polycrystalline with no preferential orientation, and the magnetization exhibits no definite anisotropy. Grain size in the films increases as X increases, reaching 0.98[${\mu}m$] at X=0.97.

Power semiconductor macro modeled by SIMULINK such as diode, thyristor. Loads are modeled by SIMULINK and PSPICE through their algorithms. For proved these modeling accurate, simulation techniques which are generally used in the field of power electronics circuits are adapted in power electronics and systems.

Optical properties of $Zn_2AgGaSe_4$ and $Zn_2AgGaSe_4$:$Co^{2+}$ crystals are investigated in the visible and near-infrared regions at 298K. The direct band gap at 298K is 1.630eV for the $Zn_2AgGaSe_4$ and 1.567eV for the $Zn_2AgGaSe_4$:$Co^{2+}$ crystals, respectively. In the optical absorption and PAS spectrum of the $Zn_2AgGaSe_4$:$Co^{2+}$, we observed five impurity absorption peaks at $4220cm^{-1}$, $5952cm^{-1}$, $12422cm^{-1}$, $12987cm^{-1}$ and $14184cm^{-1}$. These impurity absorption peaks are attributed to the electronic transitions between the split energy levels of $Co^{2+}$ ions with Td symmetry of $Zn_2AgGaSe_4$ host lattice. The crystal field parameter Dq, the Racah parameter B and the spin-orbit coupling parameter $\lambda$ are given by $442cm^{-1}$, $425cm^{-1}$ and $440cm^{-1}$, respectively.

The zero voltage and zero current switching(ZVZCS) full bridge (FB) PWM converter using secondary active clamp is characterized by high efficiency, good ZVZCS characteristic, simple topology and low cost. But at the period for discharge of the secondary clamp capacitor, peak pulses and ringing pulse occur in rectified secondary side of the converter. In this paper, a novel secondary active clamp circuit for the ZVZCS FB PWM converter is proposed and a 50 kHz, 500 W prototype converter was experimented for verification of the converter characteristics. It was verified that high voltage peak pulses and ringing pulse on secondary rectified waveforms of the converter are decreased effectively.

This paper describes the electron transport characteristics in $SF_6$+He gas calculated for range of E/N values from $50{\sim}700[Td]$ by the Monte Carlo simulation and Boltzmann equation method using a set of electron collision cross sections determined by the authors and the values of electron swarm parameters are obtained by TOF method. The results gained that the values of the electron swarm parameters such as the electron drift velocity, the electron ionization or attachment coefficients, longitudinal and transverse diffusion coefficients agree with the experimental and theoretical for a range of E/N.

본 연구에서는 $SrBi_xTa_2O_9$ 세라믹스에서 Bi 몰비 변화에 대한 x를 2.4, 2.6, 2.8, 3.0, 3.2로 변화시키면서 소결 온도도 변화하여 각각에 대한 구조 및 전기적 특성을 조사하였다. Bi 부족과 이상과잉에 따라 이상의 결정구조를 보였으며 소결온도가 높아질수록 Bi 휘발이 많아져 정방성이 떨어졌다. Sr/Bi/Ta=1/2.8/2 조성에서 가장 큰 정방성과 그레인 크기를 나타내었으며 그 조성에서 1000[$^{\circ}C$]로 소결한 시료에서 유전율 132를 보였고 1050[$^{\circ}C$]로 소결한 시료에서 잔류분극 1.134[${\mu}C/cm^2$]을 나타내었다.

This paper proposed a method to reduce torque ripple of double-layer axial flux permanent magnet motor. Torque is generated by interacting between current of stator winding and airgap flux. In the case of slotless axial flux permanent magnet motor, only commutation torque component is significant. Hence, cogging and reluctance torque will not be considered. For this propose, we were supplied differential phase current in each winding and shifted rotor magnet. According to shifted rotor magnet and flux and phase of current were shifted, phase of developed torque in each side is difference. As a result, we could reduce the total torque ripple in motor and obtain minimum torque ripple in the case of 7.5 degree shifting angle between two rotors.

This paper proposes a robust FPID(Fuzzy Proportional Integral Derivative) controller for the LFC(load frequency control) of 2-area power system. The PID gain parameters of the proposed robust FPID controller are self-tuned by PSGM(Product Sum Gravity Method) which is very similiar to human's inference procedures. As the results of simulation, the proposed FPID controller against various load disturbances shows that it is superior to the conventional control techniques such as optimal, PID and fuzzy control in the response characteristics of frequency and tie line power flow.

In the present study, we fabricated stoichiometric $(Ba_{1-x}Sr_x)TiO_3$ thin films at various substrate temperature and contents using of magnetron sputtering method on optimized Pt-based electrodes (Pt/TiN/$SiO_2$/Si). The substate temperature deposited at 200[ $^{\circ}C$], 400[$^{\circ}C$] and 600[$^{\circ}C$] and crystalline BST thin films show above 400[$^{\circ}C$]. Also, the composition of $(Ba_{1-x}Sr_x)TiO_3$ thin films deposited on Si wafer substrate at 400[$^{\circ}C$] were closed to stoichiometry($1.015{\sim}1.093$ in A/B ratio), but compositional deviation from a stoichiometry is larger as $SrCO_3$ is added. The drastic decrease of dielectric constant and increase of dielectric loss in $(Ba_{1-x}Sr_x)TiO_3$thin films is observed above 100[kHz]. V-I characteristics of $(Ba_{1-x}Sr_x)TiO_3$ thin films show the decrease of leakage current with the increase of $SrCO_3$ contents.

As our power system has changed the past undeveloped model causing the lacked supply of power to the civilized model that the remained one makes the voltage and the frequency rise at the middle of the night, the leading power factor operation of generators, that is, the under-exited operation is essentially to be needed, so, at a viewpoint of the stability of the power system, it is a very important factor. In this investigation. the equation of curves for each area on the capability curve has been studied at the above-mentioned viewpoint. Also, each capability curve for the operating power stations (Nuclear P/S, Thermal P/S, Hydrolic & pumping-up P/S Gas turbine P/S) has, been presented, and studied whether the leading power factor operational area is able to be expanded or not.

The power flow calculations(PFc) are the most important and powerful tools in power systems engineering. The conventional power flow problem is solved generally with numerical methods such as Newton-Raphson(NR). The conventional numerical method generally have some convergency problem, which is sensitive to initial value, and numerical stability problem concerned with jacobian matrix inversion. This paper presents a new PFc algorithm based on the improved genetic algorithm (IGA) which can overcome the disadvantages mentioned above. The parameters of GA, with dynamical hierarchy of the coding system, are improved to make GA a practical algorithm in the problem of real system. Some case studies with test bus system also present to show the performance of proposed algorithm. The results of proposed algorithm are compared with the results of PFc obtained using a conventional NR method.

In recent years, much attention has been paid to the voltage collapse phenomena. There has been reported many cases about the voltage collapse in many countries. These voltage collapse phenomena are known as the event that can occur due to reactive power deficits. This paper proposes an efficient method that can pursue the reactive power loss changes and gives the simple voltage collapse proximity indicator(VCPI) based on the reactive power loss sensitivities using optimal techniques. By comparing reactive power loss sensitivity with active power loss sensitivity, it is also proved that VCPI based on reactive power loss sensitivities is more effective. The developed VCPI is derived from the Jacobian matrix of Load Flow and the computational burden is very low and on-line implementation is possible. The proposed method is applied to a IEEE-14 bus test system and reliable and promising results are obtained.

This paper presents the high performance real time control system of PWM inverter for uninterruptible power supply(UPS). This system is based on a digital control scheme which calculates the pulse widths of the inverter switches for the next sampling time in digital signal processor(DSP). A PI compensator is used to eliminate the voltage error caused by the difference between the actual values of LC filter and those designed. Double regulation loops which are the inner current loop and the outer voltage loop are used to make the transient response time reduce in load disturbance and nonlinear load. This method makes it possible to obtain better response in comparison to conventional digital control system. The proposed scheme provides good performance such as stable operation, low THD of the output voltage, and good dynamic response for load variations and nonlinear load.